// SPDX-License-Identifier: GPL-2.0-only
/*
 * OMAP4 specific common source file.
 *
 * Copyright (C) 2010 Texas Instruments, Inc.
 * Author:
 *      Santosh Shilimkar <santosh.shilimkar@ti.com>
 */

#include <linux/kernel.h>
#include <linux/init.h>
#include <linux/io.h>
#include <linux/irq.h>
#include <linux/irqchip.h>
#include <linux/memblock.h>
#include <linux/of.h>
#include <linux/of_irq.h>
#include <linux/export.h>
#include <linux/irqchip/arm-gic.h>
#include <linux/of_address.h>
#include <linux/reboot.h>
#include <linux/genalloc.h>

#include <asm/hardware/cache-l2x0.h>
#include <asm/mach/map.h>
#include <asm/memblock.h>
#include <asm/smp_twd.h>

#include "omap-wakeupgen.h"
#include "soc.h"
#include "iomap.h"
#include "common.h"
#include "prminst44xx.h"
#include "prcm_mpu44xx.h"
#include "omap4-sar-layout.h"
#include "omap-secure.h"
#include "sram.h"

#ifdef CONFIG_CACHE_L2X0
static void __iomem *l2cache_base;
#endif

static void __iomem *sar_ram_base;
static void __iomem *gic_dist_base_addr;
static void __iomem *twd_base;

#define IRQ_LOCALTIMER          29

#ifdef CONFIG_OMAP_INTERCONNECT_BARRIER

/* Used to implement memory barrier on DRAM path */
#define OMAP4_DRAM_BARRIER_VA                   0xfe600000

static void __iomem *dram_sync, *sram_sync;
static phys_addr_t dram_sync_paddr;
static u32 dram_sync_size;

/*
 * The OMAP4 bus structure contains asynchronous bridges which can buffer
 * data writes from the MPU. These asynchronous bridges can be found on
 * paths between the MPU to EMIF, and the MPU to L3 interconnects.
 *
 * We need to be careful about re-ordering which can happen as a result
 * of different accesses being performed via different paths, and
 * therefore different asynchronous bridges.
 */

/*
 * OMAP4 interconnect barrier which is called for each mb() and wmb().
 * This is to ensure that normal paths to DRAM (normal memory, cacheable
 * accesses) are properly synchronised with writes to DMA coherent memory
 * (normal memory, uncacheable) and device writes.
 *
 * The mb() and wmb() barriers only operate only on the MPU->MA->EMIF
 * path, as we need to ensure that data is visible to other system
 * masters prior to writes to those system masters being seen.
 *
 * Note: the SRAM path is not synchronised via mb() and wmb().
 */
static void omap4_mb(void)
{
        if (dram_sync)
                writel_relaxed(0, dram_sync);
}

/*
 * OMAP4 Errata i688 - asynchronous bridge corruption when entering WFI.
 *
 * If a data is stalled inside asynchronous bridge because of back
 * pressure, it may be accepted multiple times, creating pointer
 * misalignment that will corrupt next transfers on that data path until
 * next reset of the system. No recovery procedure once the issue is hit,
 * the path remains consistently broken.
 *
 * Async bridges can be found on paths between MPU to EMIF and MPU to L3
 * interconnects.
 *
 * This situation can happen only when the idle is initiated by a Master
 * Request Disconnection (which is trigged by software when executing WFI
 * on the CPU).
 *
 * The work-around for this errata needs all the initiators connected
 * through an async bridge to ensure that data path is properly drained
 * before issuing WFI. This condition will be met if one Strongly ordered
 * access is performed to the target right before executing the WFI.
 *
 * In MPU case, L3 T2ASYNC FIFO and DDR T2ASYNC FIFO needs to be drained.
 * IO barrier ensure that there is no synchronisation loss on initiators
 * operating on both interconnect port simultaneously.
 *
 * This is a stronger version of the OMAP4 memory barrier below, and
 * operates on both the MPU->MA->EMIF path but also the MPU->OCP path
 * as well, and is necessary prior to executing a WFI.
 */
void omap_interconnect_sync(void)
{
        if (dram_sync && sram_sync) {
                writel_relaxed(readl_relaxed(dram_sync), dram_sync);
                writel_relaxed(readl_relaxed(sram_sync), sram_sync);
                isb();
        }
}

static int __init omap4_sram_init(void)
{
        struct device_node *np;
        struct gen_pool *sram_pool;

        if (!soc_is_omap44xx() && !soc_is_omap54xx())
                return 0;

        np = of_find_compatible_node(NULL, NULL, "ti,omap4-mpu");
        if (!np)
                pr_warn("%s:Unable to allocate sram needed to handle errata I688\n",
                        __func__);
        sram_pool = of_gen_pool_get(np, "sram", 0);
        if (!sram_pool)
                pr_warn("%s:Unable to get sram pool needed to handle errata I688\n",
                        __func__);
        else
                sram_sync = (void __iomem *)gen_pool_alloc(sram_pool, PAGE_SIZE);
        of_node_put(np);

        return 0;
}
omap_arch_initcall(omap4_sram_init);

/* Steal one page physical memory for barrier implementation */
void __init omap_barrier_reserve_memblock(void)
{
        dram_sync_size = ALIGN(PAGE_SIZE, SZ_1M);
        dram_sync_paddr = arm_memblock_steal(dram_sync_size, SZ_1M);
}

void __init omap_barriers_init(void)
{
        struct map_desc dram_io_desc[1];

        dram_io_desc[0].virtual = OMAP4_DRAM_BARRIER_VA;
        dram_io_desc[0].pfn = __phys_to_pfn(dram_sync_paddr);
        dram_io_desc[0].length = dram_sync_size;
        dram_io_desc[0].type = MT_MEMORY_RW_SO;
        iotable_init(dram_io_desc, ARRAY_SIZE(dram_io_desc));
        dram_sync = (void __iomem *) dram_io_desc[0].virtual;

        pr_info("OMAP4: Map %pa to %p for dram barrier\n",
                &dram_sync_paddr, dram_sync);

        soc_mb = omap4_mb;
}

#endif

void gic_dist_disable(void)
{
        if (gic_dist_base_addr)
                writel_relaxed(0x0, gic_dist_base_addr + GIC_DIST_CTRL);
}

void gic_dist_enable(void)
{
        if (gic_dist_base_addr)
                writel_relaxed(0x1, gic_dist_base_addr + GIC_DIST_CTRL);
}

bool gic_dist_disabled(void)
{
        return !(readl_relaxed(gic_dist_base_addr + GIC_DIST_CTRL) & 0x1);
}

void gic_timer_retrigger(void)
{
        u32 twd_int = readl_relaxed(twd_base + TWD_TIMER_INTSTAT);
        u32 gic_int = readl_relaxed(gic_dist_base_addr + GIC_DIST_PENDING_SET);
        u32 twd_ctrl = readl_relaxed(twd_base + TWD_TIMER_CONTROL);

        if (twd_int && !(gic_int & BIT(IRQ_LOCALTIMER))) {
                /*
                 * The local timer interrupt got lost while the distributor was
                 * disabled.  Ack the pending interrupt, and retrigger it.
                 */
                pr_warn("%s: lost localtimer interrupt\n", __func__);
                writel_relaxed(1, twd_base + TWD_TIMER_INTSTAT);
                if (!(twd_ctrl & TWD_TIMER_CONTROL_PERIODIC)) {
                        writel_relaxed(1, twd_base + TWD_TIMER_COUNTER);
                        twd_ctrl |= TWD_TIMER_CONTROL_ENABLE;
                        writel_relaxed(twd_ctrl, twd_base + TWD_TIMER_CONTROL);
                }
        }
}

#ifdef CONFIG_CACHE_L2X0

void __iomem *omap4_get_l2cache_base(void)
{
        return l2cache_base;
}

void omap4_l2c310_write_sec(unsigned long val, unsigned reg)
{
        unsigned smc_op;

        switch (reg) {
        case L2X0_CTRL:
                smc_op = OMAP4_MON_L2X0_CTRL_INDEX;
                break;

        case L2X0_AUX_CTRL:
                smc_op = OMAP4_MON_L2X0_AUXCTRL_INDEX;
                break;

        case L2X0_DEBUG_CTRL:
                smc_op = OMAP4_MON_L2X0_DBG_CTRL_INDEX;
                break;

        case L310_PREFETCH_CTRL:
                smc_op = OMAP4_MON_L2X0_PREFETCH_INDEX;
                break;

        case L310_POWER_CTRL:
                pr_info_once("OMAP L2C310: ROM does not support power control setting\n");
                return;

        default:
                WARN_ONCE(1, "OMAP L2C310: ignoring write to reg 0x%x\n", reg);
                return;
        }

        omap_smc1(smc_op, val);
}

int __init omap_l2_cache_init(void)
{
        /* Static mapping, never released */
        l2cache_base = ioremap(OMAP44XX_L2CACHE_BASE, SZ_4K);
        if (WARN_ON(!l2cache_base))
                return -ENOMEM;
        return 0;
}
#endif

void __iomem *omap4_get_sar_ram_base(void)
{
        return sar_ram_base;
}

/*
 * SAR RAM used to save and restore the HW context in low power modes.
 * Note that we need to initialize this very early for kexec. See
 * omap4_mpuss_early_init().
 */
void __init omap4_sar_ram_init(void)
{
        unsigned long sar_base;

        /*
         * To avoid code running on other OMAPs in
         * multi-omap builds
         */
        if (cpu_is_omap44xx())
                sar_base = OMAP44XX_SAR_RAM_BASE;
        else if (soc_is_omap54xx())
                sar_base = OMAP54XX_SAR_RAM_BASE;
        else
                return;

        /* Static mapping, never released */
        sar_ram_base = ioremap(sar_base, SZ_16K);
        if (WARN_ON(!sar_ram_base))
                return;
}

static const struct of_device_id intc_match[] = {
        { .compatible = "ti,omap4-wugen-mpu", },
        { .compatible = "ti,omap5-wugen-mpu", },
        { },
};

static struct device_node *intc_node;

void __init omap_gic_of_init(void)
{
        struct device_node *np;

        intc_node = of_find_matching_node(NULL, intc_match);
        if (WARN_ON(!intc_node)) {
                pr_err("No WUGEN found in DT, system will misbehave.\n");
                pr_err("UPDATE YOUR DEVICE TREE!\n");
        }

        /* Extract GIC distributor and TWD bases for OMAP4460 ROM Errata WA */
        if (!cpu_is_omap446x())
                goto skip_errata_init;

        np = of_find_compatible_node(NULL, NULL, "arm,cortex-a9-gic");
        gic_dist_base_addr = of_iomap(np, 0);
        of_node_put(np);
        WARN_ON(!gic_dist_base_addr);

        np = of_find_compatible_node(NULL, NULL, "arm,cortex-a9-twd-timer");
        twd_base = of_iomap(np, 0);
        of_node_put(np);
        WARN_ON(!twd_base);

skip_errata_init:
        irqchip_init();
}