// SPDX-License-Identifier: GPL-2.0-only
/*
 * arch/arm/mm/cache-feroceon-l2.c - Feroceon L2 cache controller support
 *
 * Copyright (C) 2008 Marvell Semiconductor
 *
 * References:
 * - Unified Layer 2 Cache for Feroceon CPU Cores,
 *   Document ID MV-S104858-00, Rev. A, October 23 2007.
 */

#include <linux/init.h>
#include <linux/of.h>
#include <linux/of_address.h>
#include <linux/highmem.h>
#include <linux/io.h>
#include <asm/cacheflush.h>
#include <asm/cp15.h>
#include <asm/hardware/cache-feroceon-l2.h>

#define L2_WRITETHROUGH_KIRKWOOD        BIT(4)

/*
 * Low-level cache maintenance operations.
 *
 * As well as the regular 'clean/invalidate/flush L2 cache line by
 * MVA' instructions, the Feroceon L2 cache controller also features
 * 'clean/invalidate L2 range by MVA' operations.
 *
 * Cache range operations are initiated by writing the start and
 * end addresses to successive cp15 registers, and process every
 * cache line whose first byte address lies in the inclusive range
 * [start:end].
 *
 * The cache range operations stall the CPU pipeline until completion.
 *
 * The range operations require two successive cp15 writes, in
 * between which we don't want to be preempted.
 */

static inline unsigned long l2_get_va(unsigned long paddr)
{
#ifdef CONFIG_HIGHMEM
        /*
         * Because range ops can't be done on physical addresses,
         * we simply install a virtual mapping for it only for the
         * TLB lookup to occur, hence no need to flush the untouched
         * memory mapping afterwards (note: a cache flush may happen
         * in some circumstances depending on the path taken in kunmap_atomic).
         */
        void *vaddr = kmap_atomic_pfn(paddr >> PAGE_SHIFT);
        return (unsigned long)vaddr + (paddr & ~PAGE_MASK);
#else
        return __phys_to_virt(paddr);
#endif
}

static inline void l2_put_va(unsigned long vaddr)
{
#ifdef CONFIG_HIGHMEM
        kunmap_atomic((void *)vaddr);
#endif
}

static inline void l2_clean_pa(unsigned long addr)
{
        __asm__("mcr p15, 1, %0, c15, c9, 3" : : "r" (addr));
}

static inline void l2_clean_pa_range(unsigned long start, unsigned long end)
{
        unsigned long va_start, va_end, flags;

        /*
         * Make sure 'start' and 'end' reference the same page, as
         * L2 is PIPT and range operations only do a TLB lookup on
         * the start address.
         */
        BUG_ON((start ^ end) >> PAGE_SHIFT);

        va_start = l2_get_va(start);
        va_end = va_start + (end - start);
        raw_local_irq_save(flags);
        __asm__("mcr p15, 1, %0, c15, c9, 4\n\t"
                "mcr p15, 1, %1, c15, c9, 5"
                : : "r" (va_start), "r" (va_end));
        raw_local_irq_restore(flags);
        l2_put_va(va_start);
}

static inline void l2_clean_inv_pa(unsigned long addr)
{
        __asm__("mcr p15, 1, %0, c15, c10, 3" : : "r" (addr));
}

static inline void l2_inv_pa(unsigned long addr)
{
        __asm__("mcr p15, 1, %0, c15, c11, 3" : : "r" (addr));
}

static inline void l2_inv_pa_range(unsigned long start, unsigned long end)
{
        unsigned long va_start, va_end, flags;

        /*
         * Make sure 'start' and 'end' reference the same page, as
         * L2 is PIPT and range operations only do a TLB lookup on
         * the start address.
         */
        BUG_ON((start ^ end) >> PAGE_SHIFT);

        va_start = l2_get_va(start);
        va_end = va_start + (end - start);
        raw_local_irq_save(flags);
        __asm__("mcr p15, 1, %0, c15, c11, 4\n\t"
                "mcr p15, 1, %1, c15, c11, 5"
                : : "r" (va_start), "r" (va_end));
        raw_local_irq_restore(flags);
        l2_put_va(va_start);
}

static inline void l2_inv_all(void)
{
        __asm__("mcr p15, 1, %0, c15, c11, 0" : : "r" (0));
}

/*
 * Linux primitives.
 *
 * Note that the end addresses passed to Linux primitives are
 * noninclusive, while the hardware cache range operations use
 * inclusive start and end addresses.
 */
#define CACHE_LINE_SIZE         32
#define MAX_RANGE_SIZE          1024

static int l2_wt_override;

static unsigned long calc_range_end(unsigned long start, unsigned long end)
{
        unsigned long range_end;

        BUG_ON(start & (CACHE_LINE_SIZE - 1));
        BUG_ON(end & (CACHE_LINE_SIZE - 1));

        /*
         * Try to process all cache lines between 'start' and 'end'.
         */
        range_end = end;

        /*
         * Limit the number of cache lines processed at once,
         * since cache range operations stall the CPU pipeline
         * until completion.
         */
        if (range_end > start + MAX_RANGE_SIZE)
                range_end = start + MAX_RANGE_SIZE;

        /*
         * Cache range operations can't straddle a page boundary.
         */
        if (range_end > (start | (PAGE_SIZE - 1)) + 1)
                range_end = (start | (PAGE_SIZE - 1)) + 1;

        return range_end;
}

static void feroceon_l2_inv_range(unsigned long start, unsigned long end)
{
        /*
         * Clean and invalidate partial first cache line.
         */
        if (start & (CACHE_LINE_SIZE - 1)) {
                l2_clean_inv_pa(start & ~(CACHE_LINE_SIZE - 1));
                start = (start | (CACHE_LINE_SIZE - 1)) + 1;
        }

        /*
         * Clean and invalidate partial last cache line.
         */
        if (start < end && end & (CACHE_LINE_SIZE - 1)) {
                l2_clean_inv_pa(end & ~(CACHE_LINE_SIZE - 1));
                end &= ~(CACHE_LINE_SIZE - 1);
        }

        /*
         * Invalidate all full cache lines between 'start' and 'end'.
         */
        while (start < end) {
                unsigned long range_end = calc_range_end(start, end);
                l2_inv_pa_range(start, range_end - CACHE_LINE_SIZE);
                start = range_end;
        }

        dsb();
}

static void feroceon_l2_clean_range(unsigned long start, unsigned long end)
{
        /*
         * If L2 is forced to WT, the L2 will always be clean and we
         * don't need to do anything here.
         */
        if (!l2_wt_override) {
                start &= ~(CACHE_LINE_SIZE - 1);
                end = (end + CACHE_LINE_SIZE - 1) & ~(CACHE_LINE_SIZE - 1);
                while (start != end) {
                        unsigned long range_end = calc_range_end(start, end);
                        l2_clean_pa_range(start, range_end - CACHE_LINE_SIZE);
                        start = range_end;
                }
        }

        dsb();
}

static void feroceon_l2_flush_range(unsigned long start, unsigned long end)
{
        start &= ~(CACHE_LINE_SIZE - 1);
        end = (end + CACHE_LINE_SIZE - 1) & ~(CACHE_LINE_SIZE - 1);
        while (start != end) {
                unsigned long range_end = calc_range_end(start, end);
                if (!l2_wt_override)
                        l2_clean_pa_range(start, range_end - CACHE_LINE_SIZE);
                l2_inv_pa_range(start, range_end - CACHE_LINE_SIZE);
                start = range_end;
        }

        dsb();
}


/*
 * Routines to disable and re-enable the D-cache and I-cache at run
 * time.  These are necessary because the L2 cache can only be enabled
 * or disabled while the L1 Dcache and Icache are both disabled.
 */
static int __init flush_and_disable_dcache(void)
{
        u32 cr;

        cr = get_cr();
        if (cr & CR_C) {
                unsigned long flags;

                raw_local_irq_save(flags);
                flush_cache_all();
                set_cr(cr & ~CR_C);
                raw_local_irq_restore(flags);
                return 1;
        }
        return 0;
}

static void __init enable_dcache(void)
{
        u32 cr;

        cr = get_cr();
        set_cr(cr | CR_C);
}

static void __init __invalidate_icache(void)
{
        __asm__("mcr p15, 0, %0, c7, c5, 0" : : "r" (0));
}

static int __init invalidate_and_disable_icache(void)
{
        u32 cr;

        cr = get_cr();
        if (cr & CR_I) {
                set_cr(cr & ~CR_I);
                __invalidate_icache();
                return 1;
        }
        return 0;
}

static void __init enable_icache(void)
{
        u32 cr;

        cr = get_cr();
        set_cr(cr | CR_I);
}

static inline u32 read_extra_features(void)
{
        u32 u;

        __asm__("mrc p15, 1, %0, c15, c1, 0" : "=r" (u));

        return u;
}

static inline void __init write_extra_features(u32 u)
{
        __asm__("mcr p15, 1, %0, c15, c1, 0" : : "r" (u));
}

static void __init disable_l2_prefetch(void)
{
        u32 u;

        /*
         * Read the CPU Extra Features register and verify that the
         * Disable L2 Prefetch bit is set.
         */
        u = read_extra_features();
        if (!(u & 0x01000000)) {
                pr_info("Feroceon L2: Disabling L2 prefetch.\n");
                write_extra_features(u | 0x01000000);
        }
}

static void __init enable_l2(void)
{
        u32 u;

        u = read_extra_features();
        if (!(u & 0x00400000)) {
                int i, d;

                pr_info("Feroceon L2: Enabling L2\n");

                d = flush_and_disable_dcache();
                i = invalidate_and_disable_icache();
                l2_inv_all();
                write_extra_features(u | 0x00400000);
                if (i)
                        enable_icache();
                if (d)
                        enable_dcache();
        } else
                pr_err(FW_BUG
                       "Feroceon L2: bootloader left the L2 cache on!\n");
}

void __init feroceon_l2_init(int __l2_wt_override)
{
        l2_wt_override = __l2_wt_override;

        disable_l2_prefetch();

        outer_cache.inv_range = feroceon_l2_inv_range;
        outer_cache.clean_range = feroceon_l2_clean_range;
        outer_cache.flush_range = feroceon_l2_flush_range;

        enable_l2();

        pr_info("Feroceon L2: Cache support initialised%s.\n",
                         l2_wt_override ? ", in WT override mode" : "");
}
#ifdef CONFIG_OF
static const struct of_device_id feroceon_ids[] __initconst = {
        { .compatible = "marvell,kirkwood-cache"},
        { .compatible = "marvell,feroceon-cache"},
        {}
};

int __init feroceon_of_init(void)
{
        struct device_node *node;
        void __iomem *base;
        bool l2_wt_override = false;

#if defined(CONFIG_CACHE_FEROCEON_L2_WRITETHROUGH)
        l2_wt_override = true;
#endif

        node = of_find_matching_node(NULL, feroceon_ids);
        if (node && of_device_is_compatible(node, "marvell,kirkwood-cache")) {
                base = of_iomap(node, 0);
                if (!base)
                        return -ENOMEM;

                if (l2_wt_override)
                        writel(readl(base) | L2_WRITETHROUGH_KIRKWOOD, base);
                else
                        writel(readl(base) & ~L2_WRITETHROUGH_KIRKWOOD, base);
        }

        feroceon_l2_init(l2_wt_override);

        return 0;
}
#endif