root/sys/dev/ic/lsi64854reg.h
/*      $OpenBSD: lsi64854reg.h,v 1.4 2008/06/26 05:42:15 ray Exp $     */
/*      $NetBSD: lsi64854reg.h,v 1.5 2001/03/29 02:58:39 petrov Exp $ */

/*-
 * Copyright (c) 1998 The NetBSD Foundation, Inc.
 * All rights reserved.
 *
 * This code is derived from software contributed to The NetBSD Foundation
 * by Paul Kranenburg.
 *
 * Redistribution and use in source and binary forms, with or without
 * modification, are permitted provided that the following conditions
 * are met:
 * 1. Redistributions of source code must retain the above copyright
 *    notice, this list of conditions and the following disclaimer.
 * 2. Redistributions in binary form must reproduce the above copyright
 *    notice, this list of conditions and the following disclaimer in the
 *    documentation and/or other materials provided with the distribution.
 *
 * THIS SOFTWARE IS PROVIDED BY THE NETBSD FOUNDATION, INC. AND CONTRIBUTORS
 * ``AS IS'' AND ANY EXPRESS OR IMPLIED WARRANTIES, INCLUDING, BUT NOT LIMITED
 * TO, THE IMPLIED WARRANTIES OF MERCHANTABILITY AND FITNESS FOR A PARTICULAR
 * PURPOSE ARE DISCLAIMED.  IN NO EVENT SHALL THE FOUNDATION OR CONTRIBUTORS
 * BE LIABLE FOR ANY DIRECT, INDIRECT, INCIDENTAL, SPECIAL, EXEMPLARY, OR
 * CONSEQUENTIAL DAMAGES (INCLUDING, BUT NOT LIMITED TO, PROCUREMENT OF
 * SUBSTITUTE GOODS OR SERVICES; LOSS OF USE, DATA, OR PROFITS; OR BUSINESS
 * INTERRUPTION) HOWEVER CAUSED AND ON ANY THEORY OF LIABILITY, WHETHER IN
 * CONTRACT, STRICT LIABILITY, OR TORT (INCLUDING NEGLIGENCE OR OTHERWISE)
 * ARISING IN ANY WAY OUT OF THE USE OF THIS SOFTWARE, EVEN IF ADVISED OF THE
 * POSSIBILITY OF SUCH DAMAGE.
 */

/*
 * LSI 64854 DMA engine. Contains three independent channels
 * designed to interface with (a) a NCR539X SCSI controller,
 * (b) a AM7990 Ethernet controller, (c) Parallel port hardware..
 */

/*
 * Register offsets to bus handle.
 */
#define L64854_REG_CSR          0               /* Control bits */
#define L64854_REG_ADDR         4               /* DMA Address */
#define L64854_REG_CNT          8               /* DMA count */
#define L64854_REG_CNT_MASK     0x00ffffff      /*   only 24 bits */
#define L64854_REG_ENBAR        12              /* ENET Base register */
#define L64854_REG_TEST         12              /* SCSI Test register */
#define L64854_REG_HCR          16              /* PP Hardware Configuration */
#define L64854_REG_OCR          18              /* PP Operation Configuration */
#define L64854_REG_DR           20              /* PP Data register */
#define L64854_REG_TCR          21              /* PP Transfer Control */
#define L64854_REG_OR           22              /* PP Output register */
#define L64854_REG_IR           23              /* PP Input register */
#define L64854_REG_ICR          24              /* PP Interrupt Control */


/*
 * Control bits common to all three channels.
 */
#define L64854_INT_PEND 0x00000001      /* Interrupt pending */
#define L64854_ERR_PEND 0x00000002      /* Error pending */
#define L64854_DRAINING 0x0000000c      /* FIFO draining */
#define L64854_INT_EN   0x00000010      /* Interrupt enable */
#define L64854_INVALIDATE       0x00000020      /* Invalidate FIFO */
#define L64854_SLAVE_ERR        0x00000040      /* Slave access size error */
#define L64854_RESET    0x00000080      /* Reset device */
#define L64854_WRITE    0x00000100      /* 1: xfer to memory */
#define L64854_EN_DMA   0x00000200      /* enable DMA transfers */

#define L64854_BURST_SIZE       0x000c0000      /* Read/write burst size */
#define  L64854_BURST_0         0x00080000      /*   no bursts (SCSI-only) */
#define  L64854_BURST_16        0x00000000      /*   16-byte bursts */
#define  L64854_BURST_32        0x00040000      /*   32-byte bursts */
#define  L64854_BURST_64        0x000c0000      /*   64-byte bursts (fas) */

#define L64854_RST_FAS366       0x08000000      /* FAS366 hardware reset */

#define L64854_DEVID            0xf0000000      /* device ID bits */

/*
 * SCSI DMA control bits.
 */
#define D_INT_PEND      L64854_INT_PEND /* interrupt pending */
#define D_ERR_PEND      L64854_ERR_PEND /* error pending */
#define D_DRAINING      L64854_DRAINING /* fifo draining */
#define D_INT_EN        L64854_INT_EN   /* interrupt enable */
#define D_INVALIDATE    L64854_INVALIDATE/* invalidate fifo */
#define D_SLAVE_ERR     L64854_SLAVE_ERR/* slave access size error */
#define D_RESET         L64854_RESET    /* reset scsi */
#define D_WRITE         L64854_WRITE    /* 1 = dev -> mem */
#define D_EN_DMA        L64854_EN_DMA   /* enable DMA requests */
#define D_EN_CNT        0x00002000      /* enable byte counter */
#define D_TC            0x00004000      /* terminal count */
#define D_WIDE_EN       0x00008000      /* enable wide mode SBUS DMA (fas) */
#define D_DSBL_CSR_DRN  0x00010000      /* disable fifo drain on csr */
#define D_DSBL_SCSI_DRN 0x00020000      /* disable fifo drain on reg */

#define D_DIAG          0x00100000      /* disable fifo drain on addr */
#define D_TWO_CYCLE     0x00200000      /* 2 clocks per transfer */
#define D_FASTER        0x00400000      /* 3 clocks per transfer */
#define D_TCI_DIS       0x00800000      /* disable intr on D_TC */
#define D_EN_NEXT       0x01000000      /* enable auto next address */
#define D_DMA_ON        0x02000000      /* enable dma from scsi XXX */
#define D_DSBL_PARITY_CHK \
                        0x02000000      /* disable checking for parity on bus (default 1:fas) */
#define D_A_LOADED      0x04000000      /* address loaded */
#define D_NA_LOADED     0x08000000      /* next address loaded */
#define D_HW_RESET_FAS366 \
                        0x08000000      /* hardware reset FAS366 (fas) */
#define D_DEV_ID        L64854_DEVID    /* device ID */
#define  DMAREV_0       0x00000000      /* Sunray DMA */
#define  DMAREV_ESC     0x40000000      /*  DMA ESC array */
#define  DMAREV_1       0x80000000      /* 'DMA' */
#define  DMAREV_PLUS    0x90000000      /* 'DMA+' */
#define  DMAREV_2       0xa0000000      /* 'DMA2' */
#define  DMAREV_HME     0xb0000000      /* 'HME'  */

/*
 * revisions 0,1 and ESC have different bits.
 */
#define D_ESC_DRAIN     0x00000040      /* rev0,1,esc: drain fifo */
#define D_ESC_R_PEND    0x00000400      /* rev0,1: request pending */
#define D_ESC_BURST     0x00000800      /* DMA ESC: 16 byte bursts */
#define D_ESC_AUTODRAIN 0x00040000      /* DMA ESC: Auto-drain */

#define DDMACSR_BITS    "\020"                          \
        "\01INT\02ERR\03DR1\04DR2\05IEN"                \
        "\07SLVERR\010RST\011WRITE\012ENDMA"            \
        "\016ENCNT\017TC\021DSBL_CSR_DRN"               \
        "\022DSBL_SCSI_DRN\026TWOCYCLE"                 \
        "\027FASTER\030TCIDIS\031ENNXT\032DMAON"        \
        "\033ALOADED\034NALOADED"


/*
 * ENET DMA control bits.
 */
#define E_INT_PEND      L64854_INT_PEND /* interrupt pending */
#define E_ERR_PEND      L64854_ERR_PEND /* error pending */
#define E_DRAINING      L64854_DRAINING /* fifo draining */
#define E_INT_EN        L64854_INT_EN   /* interrupt enable */
#define E_INVALIDATE    L64854_INVALIDATE/* invalidate fifo */
#define E_SLAVE_ERR     L64854_SLAVE_ERR/* slave access size error */
#define E_RESET         L64854_RESET    /* reset ENET */
#define E_reserved1     0x00000300      /* */
#define E_DRAIN         0x00000400      /* force Ecache drain */
#define E_DSBL_WR_DRN   0x00000800      /* disable Ecache drain on .. */
#define E_DSBL_RD_DRN   0x00001000      /* disable Ecache drain on .. */
#define E_reserved2     0x00006000      /* */
#define E_ILACC         0x00008000      /* ... */
#define E_DSBL_BUF_WR   0x00010000      /* no buffering of slave writes */
#define E_DSBL_WR_INVAL 0x00020000      /* no Ecache invalidate on slave writes */

#define E_reserved3     0x00100000      /* */
#define E_LOOP_TEST     0x00200000      /* loopback mode */
#define E_TP_AUI        0x00400000      /* 1 for TP, 0 for AUI */
#define E_reserved4     0x0c800000      /* */
#define E_DEV_ID        L64854_DEVID    /* ID bits */

#define EDMACSR_BITS    "\020"                          \
        "\01INT\02ERR\05IEN"                            \
        "\07SLVERR\010RST\011WRITE\013DRAIN"            \
        "\014DSBL_WR_DRN\015DSBL_RD_DRN\020ILACC"       \
        "\021DSBL_BUF_WR\022DSBL_WR_INVAL"              \
        "\026LOOPTEST\027TP"

/*
 * PP DMA control bits.
 */
#define P_INT_PEND      L64854_INT_PEND /* interrupt pending */
#define P_ERR_PEND      L64854_ERR_PEND /* error pending */
#define P_DRAINING      L64854_DRAINING /* fifo draining */
#define P_INT_EN        L64854_INT_EN   /* interrupt enable */
#define P_INVALIDATE    L64854_INVALIDATE/* invalidate fifo */
#define P_SLAVE_ERR     L64854_SLAVE_ERR/* slave access size error */
#define P_RESET         L64854_RESET    /* reset PP */
#define P_WRITE         L64854_WRITE    /* 1: xfer to memory */
#define P_EN_DMA        L64854_EN_DMA   /* enable DMA transfers */
#define P_reserved1     0x00001c00      /* */
#define P_EN_CNT        0x00002000      /* enable counter */
#define P_TC            0x00004000      /* terminal count */
#define P_reserved2     0x00038000      /* */

#define P_DIAG          0x00100000      /* ... */
#define P_reserved3     0x00600000      /* */
#define P_TCI_DIS       0x00800000      /* no interrupt on terminal count */
#define P_EN_NEXT       0x01000000      /* enable DMA chaining */
#define P_DMA_ON        0x02000000      /* DMA xfers enabled */
#define P_A_LOADED      0x04000000      /* addr and byte count valid */
#define P_NA_LOADED     0x08000000      /* next addr & count valid but not used */
#define P_DEV_ID        L64854_DEVID    /* ID bits */

#define PDMACSR_BITS    "\020"                          \
        "\01INT\02ERR\05IEN"                            \
        "\07SLVERR\010RST\011WRITE\012ENDMA"            \
        "\016ENCNT\017TC\025DIAG\030TCIDIS"             \
        "\031ENNXT\032DMAON\033ALOADED\034NALOADED"