/*      $OpenBSD: if_auereg.h,v 1.18 2015/06/18 10:02:49 mpi Exp $ */
/*      $NetBSD: if_auereg.h,v 1.16 2001/10/10 02:14:17 augustss Exp $  */
/*
 * Copyright (c) 1997, 1998, 1999
 *      Bill Paul <wpaul@ee.columbia.edu>.  All rights reserved.
 *
 * Redistribution and use in source and binary forms, with or without
 * modification, are permitted provided that the following conditions
 * are met:
 * 1. Redistributions of source code must retain the above copyright
 *    notice, this list of conditions and the following disclaimer.
 * 2. Redistributions in binary form must reproduce the above copyright
 *    notice, this list of conditions and the following disclaimer in the
 *    documentation and/or other materials provided with the distribution.
 * 3. All advertising materials mentioning features or use of this software
 *    must display the following acknowledgement:
 *      This product includes software developed by Bill Paul.
 * 4. Neither the name of the author nor the names of any co-contributors
 *    may be used to endorse or promote products derived from this software
 *    without specific prior written permission.
 *
 * THIS SOFTWARE IS PROVIDED BY Bill Paul AND CONTRIBUTORS ``AS IS'' AND
 * ANY EXPRESS OR IMPLIED WARRANTIES, INCLUDING, BUT NOT LIMITED TO, THE
 * IMPLIED WARRANTIES OF MERCHANTABILITY AND FITNESS FOR A PARTICULAR PURPOSE
 * ARE DISCLAIMED.  IN NO EVENT SHALL Bill Paul OR THE VOICES IN HIS HEAD
 * BE LIABLE FOR ANY DIRECT, INDIRECT, INCIDENTAL, SPECIAL, EXEMPLARY, OR
 * CONSEQUENTIAL DAMAGES (INCLUDING, BUT NOT LIMITED TO, PROCUREMENT OF
 * SUBSTITUTE GOODS OR SERVICES; LOSS OF USE, DATA, OR PROFITS; OR BUSINESS
 * INTERRUPTION) HOWEVER CAUSED AND ON ANY THEORY OF LIABILITY, WHETHER IN
 * CONTRACT, STRICT LIABILITY, OR TORT (INCLUDING NEGLIGENCE OR OTHERWISE)
 * ARISING IN ANY WAY OUT OF THE USE OF THIS SOFTWARE, EVEN IF ADVISED OF
 * THE POSSIBILITY OF SUCH DAMAGE.
 *
 * $FreeBSD: src/sys/dev/usb/if_auereg.h,v 1.2 2000/01/08 06:52:36 wpaul Exp $
 */

/*
 * Register definitions for ADMtek Pegasus AN986 USB to Ethernet
 * chip. The Pegasus uses a total of four USB endpoints: the control
 * endpoint (0), a bulk read endpoint for receiving packets (1),
 * a bulk write endpoint for sending packets (2) and an interrupt
 * endpoint for passing RX and TX status (3). Endpoint 0 is used
 * to read and write the ethernet module's registers. All registers
 * are 8 bits wide.
 *
 * Packet transfer is done in 64 byte chunks. The last chunk in a
 * transfer is denoted by having a length less that 64 bytes. For
 * the RX case, the data includes an optional RX status word.
 */

#define AUE_UR_READREG          0xF0
#define AUE_UR_WRITEREG         0xF1

/*
 * Note that while the ADMtek technically has four
 * endpoints, the control endpoint (endpoint 0) is
 * regarded as special by the USB code and drivers
 * don't have direct access to it. (We access it
 * using usbd_do_request() when reading/writing
 * registers.) Consequently, our endpoint indexes
 * don't match those in the ADMtek Pegasus manual:
 * we consider the RX data endpoint to be index 0
 * and work up from there.
 */
#define AUE_ENDPT_RX            0x0
#define AUE_ENDPT_TX            0x1
#define AUE_ENDPT_INTR          0x2
#define AUE_ENDPT_MAX           0x3

#define AUE_CTL0                0x00
#define AUE_CTL1                0x01
#define AUE_CTL2                0x02
#define AUE_MAR0                0x08
#define AUE_MAR1                0x09
#define AUE_MAR2                0x0A
#define AUE_MAR3                0x0B
#define AUE_MAR4                0x0C
#define AUE_MAR5                0x0D
#define AUE_MAR6                0x0E
#define AUE_MAR7                0x0F
#define AUE_MAR                 AUE_MAR0
#define AUE_PAR0                0x10
#define AUE_PAR1                0x11
#define AUE_PAR2                0x12
#define AUE_PAR3                0x13
#define AUE_PAR4                0x14
#define AUE_PAR5                0x15
#define AUE_PAR                 AUE_PAR0
#define AUE_PAUSE0              0x18
#define AUE_PAUSE1              0x19
#define AUE_PAUSE               AUE_PAUSE0
#define AUE_RX_FLOWCTL_CNT      0x1A
#define AUE_RX_FLOWCTL_FIFO     0x1B
#define AUE_REG_1D              0x1D
#define AUE_EE_REG              0x20
#define AUE_EE_DATA0            0x21
#define AUE_EE_DATA1            0x22
#define AUE_EE_DATA             AUE_EE_DATA0
#define AUE_EE_CTL              0x23
#define AUE_PHY_ADDR            0x25
#define AUE_PHY_DATA0           0x26
#define AUE_PHY_DATA1           0x27
#define AUE_PHY_DATA            AUE_PHY_DATA0
#define AUE_PHY_CTL             0x28
#define AUE_USB_STS             0x2A
#define AUE_TXSTAT0             0x2B
#define AUE_TXSTAT1             0x2C
#define AUE_TXSTAT              AUE_TXSTAT0
#define AUE_RXSTAT              0x2D
#define AUE_PKTLOST0            0x2E
#define AUE_PKTLOST1            0x2F
#define AUE_PKTLOST             AUE_PKTLOST0

#define AUE_REG_7B              0x7B
#define AUE_GPIO0               0x7E
#define AUE_GPIO1               0x7F
#define AUE_REG_81              0x81

#define AUE_CTL0_INCLUDE_RXCRC  0x01
#define AUE_CTL0_ALLMULTI       0x02
#define AUE_CTL0_STOP_BACKOFF   0x04
#define AUE_CTL0_RXSTAT_APPEND  0x08
#define AUE_CTL0_WAKEON_ENB     0x10
#define AUE_CTL0_RXPAUSE_ENB    0x20
#define AUE_CTL0_RX_ENB         0x40
#define AUE_CTL0_TX_ENB         0x80

#define AUE_CTL1_HOMELAN        0x04
#define AUE_CTL1_RESETMAC       0x08
#define AUE_CTL1_SPEEDSEL       0x10    /* 0 = 10mbps, 1 = 100mbps */
#define AUE_CTL1_DUPLEX         0x20    /* 0 = half, 1 = full */
#define AUE_CTL1_DELAYHOME      0x40

#define AUE_CTL2_EP3_CLR        0x01    /* reading EP3 clrs status regs */
#define AUE_CTL2_RX_BADFRAMES   0x02
#define AUE_CTL2_RX_PROMISC     0x04
#define AUE_CTL2_LOOPBACK       0x08
#define AUE_CTL2_EEPROMWR_ENB   0x10
#define AUE_CTL2_EEPROM_LOAD    0x20

#define AUE_EECTL_WRITE         0x01
#define AUE_EECTL_READ          0x02
#define AUE_EECTL_DONE          0x04

#define AUE_PHYCTL_PHYREG       0x1F
#define AUE_PHYCTL_WRITE        0x20
#define AUE_PHYCTL_READ         0x40
#define AUE_PHYCTL_DONE         0x80

#define AUE_USBSTS_SUSPEND      0x01
#define AUE_USBSTS_RESUME       0x02

#define AUE_TXSTAT0_JABTIMO     0x04
#define AUE_TXSTAT0_CARLOSS     0x08
#define AUE_TXSTAT0_NOCARRIER   0x10
#define AUE_TXSTAT0_LATECOLL    0x20
#define AUE_TXSTAT0_EXCESSCOLL  0x40
#define AUE_TXSTAT0_UNDERRUN    0x80

#define AUE_TXSTAT1_PKTCNT      0x0F
#define AUE_TXSTAT1_FIFO_EMPTY  0x40
#define AUE_TXSTAT1_FIFO_FULL   0x80

#define AUE_RXSTAT_OVERRUN      0x01
#define AUE_RXSTAT_PAUSE        0x02

#define AUE_GPIO_IN0            0x01
#define AUE_GPIO_OUT0           0x02
#define AUE_GPIO_SEL0           0x04
#define AUE_GPIO_IN1            0x08
#define AUE_GPIO_OUT1           0x10
#define AUE_GPIO_SEL1           0x20

struct aue_intrpkt {
        u_int8_t                aue_txstat0;
        u_int8_t                aue_txstat1;
        u_int8_t                aue_rxstat;
        u_int8_t                aue_rxlostpkt0;
        u_int8_t                aue_rxlostpkt1;
        u_int8_t                aue_wakeupstat;
        u_int8_t                aue_rsvd;
        u_int8_t                _pad;
};
#define AUE_INTR_PKTLEN 8

struct aue_rxpkt {
        uWord                   aue_pktlen;
        uByte                   aue_rxstat;
};

#define AUE_RXSTAT_MCAST        0x01
#define AUE_RXSTAT_GIANT        0x02
#define AUE_RXSTAT_RUNT         0x04
#define AUE_RXSTAT_CRCERR       0x08
#define AUE_RXSTAT_DRIBBLE      0x10
#define AUE_RXSTAT_MASK         0x1E


/*************** The rest belongs in if_auevar.h *************/

#define AUE_TX_LIST_CNT         1
#define AUE_RX_LIST_CNT         1

struct aue_softc;

struct aue_chain {
        struct aue_softc        *aue_sc;
        struct usbd_xfer        *aue_xfer;
        char                    *aue_buf;
        struct mbuf             *aue_mbuf;
        int                     aue_idx;
};

struct aue_cdata {
        struct aue_chain        aue_tx_chain[AUE_TX_LIST_CNT];
        struct aue_chain        aue_rx_chain[AUE_RX_LIST_CNT];
        struct aue_intrpkt      aue_ibuf;
        int                     aue_tx_prod;
        int                     aue_tx_cons;
        int                     aue_tx_cnt;
        int                     aue_rx_prod;
};

struct aue_softc {
        struct device           aue_dev;

        struct arpcom           arpcom;
        struct mii_data         aue_mii;
#define GET_IFP(sc) (&(sc)->arpcom.ac_if)
#define GET_MII(sc) (&(sc)->aue_mii)

        struct timeout          aue_stat_ch;

        struct usbd_device      *aue_udev;
        struct usbd_interface   *aue_iface;
        u_int16_t               aue_vendor;
        u_int16_t               aue_product;
        int                     aue_ed[AUE_ENDPT_MAX];
        struct usbd_pipe        *aue_ep[AUE_ENDPT_MAX];
        u_int8_t                aue_link;
        struct aue_cdata        aue_cdata;

        u_int16_t               aue_flags;

        int                     aue_refcnt;
        u_int                   aue_rx_errs;
        u_int                   aue_intr_errs;
        struct timeval          aue_rx_notice;

        struct usb_task         aue_tick_task;
        struct usb_task         aue_stop_task;

        struct rwlock           aue_mii_lock;
};

#define AUE_TIMEOUT             1000
#define AUE_BUFSZ               1536
#define AUE_MIN_FRAMELEN        60
#define AUE_TX_TIMEOUT          10000 /* ms */
#define AUE_INTR_INTERVAL       100 /* ms */