root/drivers/media/usb/gspca/stv06xx/stv06xx_hdcs.h
/* SPDX-License-Identifier: GPL-2.0-or-later */
/*
 * Copyright (c) 2001 Jean-Fredric Clere, Nikolas Zimmermann, Georg Acher
 *                    Mark Cave-Ayland, Carlo E Prelz, Dick Streefland
 * Copyright (c) 2002, 2003 Tuukka Toivonen
 * Copyright (c) 2008 Erik Andrén
 * Copyright (c) 2008 Chia-I Wu
 *
 * P/N 861037:      Sensor HDCS1000        ASIC STV0600
 * P/N 861050-0010: Sensor HDCS1000        ASIC STV0600
 * P/N 861050-0020: Sensor Photobit PB100  ASIC STV0600-1 - QuickCam Express
 * P/N 861055:      Sensor ST VV6410       ASIC STV0610   - LEGO cam
 * P/N 861075-0040: Sensor HDCS1000        ASIC
 * P/N 961179-0700: Sensor ST VV6410       ASIC STV0602   - Dexxa WebCam USB
 * P/N 861040-0000: Sensor ST VV6410       ASIC STV0610   - QuickCam Web
 */

#ifndef STV06XX_HDCS_H_
#define STV06XX_HDCS_H_

#include "stv06xx_sensor.h"

#define HDCS_REG_CONFIG(sd)     (IS_1020(sd) ? HDCS20_CONFIG : HDCS00_CONFIG)
#define HDCS_REG_CONTROL(sd)    (IS_1020(sd) ? HDCS20_CONTROL : HDCS00_CONTROL)

#define HDCS_1X00_DEF_WIDTH     360
#define HDCS_1X00_DEF_HEIGHT    296

#define HDCS_1020_DEF_WIDTH     352
#define HDCS_1020_DEF_HEIGHT    292

#define HDCS_1020_BOTTOM_Y_SKIP 4

#define HDCS_CLK_FREQ_MHZ       25

#define HDCS_ADC_START_SIG_DUR  3

/* LSB bit of I2C or register address signifies write (0) or read (1) */
/* I2C Registers common for both HDCS-1000/1100 and HDCS-1020 */
/* Identifications Register */
#define HDCS_IDENT              (0x00 << 1)
/* Status Register */
#define HDCS_STATUS             (0x01 << 1)
/* Interrupt Mask Register */
#define HDCS_IMASK              (0x02 << 1)
/* Pad Control Register */
#define HDCS_PCTRL              (0x03 << 1)
/* Pad Drive Control Register */
#define HDCS_PDRV               (0x04 << 1)
/* Interface Control Register */
#define HDCS_ICTRL              (0x05 << 1)
/* Interface Timing Register */
#define HDCS_ITMG               (0x06 << 1)
/* Baud Fraction Register */
#define HDCS_BFRAC              (0x07 << 1)
/* Baud Rate Register */
#define HDCS_BRATE              (0x08 << 1)
/* ADC Control Register */
#define HDCS_ADCCTRL            (0x09 << 1)
/* First Window Row Register */
#define HDCS_FWROW              (0x0a << 1)
/* First Window Column Register */
#define HDCS_FWCOL              (0x0b << 1)
/* Last Window Row Register */
#define HDCS_LWROW              (0x0c << 1)
/* Last Window Column Register */
#define HDCS_LWCOL              (0x0d << 1)
/* Timing Control Register */
#define HDCS_TCTRL              (0x0e << 1)
/* PGA Gain Register: Even Row, Even Column */
#define HDCS_ERECPGA            (0x0f << 1)
/* PGA Gain Register: Even Row, Odd Column */
#define HDCS_EROCPGA            (0x10 << 1)
/* PGA Gain Register: Odd Row, Even Column */
#define HDCS_ORECPGA            (0x11 << 1)
/* PGA Gain Register: Odd Row, Odd Column */
#define HDCS_OROCPGA            (0x12 << 1)
/* Row Exposure Low Register */
#define HDCS_ROWEXPL            (0x13 << 1)
/* Row Exposure High Register */
#define HDCS_ROWEXPH            (0x14 << 1)

/* I2C Registers only for HDCS-1000/1100 */
/* Sub-Row Exposure Low Register */
#define HDCS00_SROWEXPL         (0x15 << 1)
/* Sub-Row Exposure High Register */
#define HDCS00_SROWEXPH         (0x16 << 1)
/* Configuration Register */
#define HDCS00_CONFIG           (0x17 << 1)
/* Control Register */
#define HDCS00_CONTROL          (0x18 << 1)

/* I2C Registers only for HDCS-1020 */
/* Sub-Row Exposure Register */
#define HDCS20_SROWEXP          (0x15 << 1)
/* Error Control Register */
#define HDCS20_ERROR            (0x16 << 1)
/* Interface Timing 2 Register */
#define HDCS20_ITMG2            (0x17 << 1)
/* Interface Control 2 Register */
#define HDCS20_ICTRL2           (0x18 << 1)
/* Horizontal Blank Register */
#define HDCS20_HBLANK           (0x19 << 1)
/* Vertical Blank Register */
#define HDCS20_VBLANK           (0x1a << 1)
/* Configuration Register */
#define HDCS20_CONFIG           (0x1b << 1)
/* Control Register */
#define HDCS20_CONTROL          (0x1c << 1)

#define HDCS_RUN_ENABLE         (1 << 2)
#define HDCS_SLEEP_MODE         (1 << 1)

#define HDCS_DEFAULT_EXPOSURE   48
#define HDCS_DEFAULT_GAIN       50

static int hdcs_probe_1x00(struct sd *sd);
static int hdcs_probe_1020(struct sd *sd);
static int hdcs_start(struct sd *sd);
static int hdcs_init(struct sd *sd);
static int hdcs_init_controls(struct sd *sd);
static int hdcs_stop(struct sd *sd);
static int hdcs_dump(struct sd *sd);

static int hdcs_set_exposure(struct gspca_dev *gspca_dev, __s32 val);
static int hdcs_set_gain(struct gspca_dev *gspca_dev, __s32 val);

const struct stv06xx_sensor stv06xx_sensor_hdcs1x00 = {
        .name = "HP HDCS-1000/1100",
        .i2c_flush = 0,
        .i2c_addr = (0x55 << 1),
        .i2c_len = 1,

        /* FIXME (see if we can lower min_packet_size, needs testing, and also
           adjusting framerate when the bandwidth gets lower) */
        .min_packet_size = { 847 },
        .max_packet_size = { 847 },

        .init = hdcs_init,
        .init_controls = hdcs_init_controls,
        .probe = hdcs_probe_1x00,
        .start = hdcs_start,
        .stop = hdcs_stop,
        .dump = hdcs_dump,
};

const struct stv06xx_sensor stv06xx_sensor_hdcs1020 = {
        .name = "HDCS-1020",
        .i2c_flush = 0,
        .i2c_addr = (0x55 << 1),
        .i2c_len = 1,

        /* FIXME (see if we can lower min_packet_size, needs testing, and also
           adjusting framerate when the bandwidthm gets lower) */
        .min_packet_size = { 847 },
        .max_packet_size = { 847 },

        .init = hdcs_init,
        .init_controls = hdcs_init_controls,
        .probe = hdcs_probe_1020,
        .start = hdcs_start,
        .stop = hdcs_stop,
        .dump = hdcs_dump,
};

static const u16 stv_bridge_init[][2] = {
        {STV_ISO_ENABLE, 0},
        {STV_REG23, 0},
        {STV_REG00, 0x1d},
        {STV_REG01, 0xb5},
        {STV_REG02, 0xa8},
        {STV_REG03, 0x95},
        {STV_REG04, 0x07},

        {STV_SCAN_RATE, 0x20},
        {STV_Y_CTRL, 0x01},
        {STV_X_CTRL, 0x0a}
};

static const u8 stv_sensor_init[][2] = {
        /* Clear status (writing 1 will clear the corresponding status bit) */
        {HDCS_STATUS, BIT(6) | BIT(5) | BIT(4) | BIT(3) | BIT(2) | BIT(1)},
        /* Disable all interrupts */
        {HDCS_IMASK, 0x00},
        {HDCS_PCTRL, BIT(6) | BIT(5) | BIT(1) | BIT(0)},
        {HDCS_PDRV,  0x00},
        {HDCS_ICTRL, BIT(5)},
        {HDCS_ITMG,  BIT(4) | BIT(1)},
        /* ADC output resolution to 10 bits */
        {HDCS_ADCCTRL, 10}
};

#endif