/* * vg468.h 1.11 1999/10/25 20:03:34 * * The contents of this file are subject to the Mozilla Public License * Version 1.1 (the "License"); you may not use this file except in * compliance with the License. You may obtain a copy of the License * at http://www.mozilla.org/MPL/ * * Software distributed under the License is distributed on an "AS IS" * basis, WITHOUT WARRANTY OF ANY KIND, either express or implied. See * the License for the specific language governing rights and * limitations under the License. * * The initial developer of the original code is David A. Hinds * <dahinds@users.sourceforge.net>. Portions created by David A. Hinds * are Copyright (C) 1999 David A. Hinds. All Rights Reserved. * * Alternatively, the contents of this file may be used under the * terms of the GNU General Public License version 2 (the "GPL"), in which * case the provisions of the GPL are applicable instead of the * above. If you wish to allow the use of your version of this file * only under the terms of the GPL and not to allow others to use * your version of this file under the MPL, indicate your decision by * deleting the provisions above and replace them with the notice and * other provisions required by the GPL. If you do not delete the * provisions above, a recipient may use your version of this file * under either the MPL or the GPL. */ #ifndef _LINUX_VG468_H #define _LINUX_VG468_H /* Special bit in I365_IDENT used for Vadem chip detection */ #define I365_IDENT_VADEM 0x08 /* Special definitions in I365_POWER */ #define VG468_VPP2_MASK 0x0c #define VG468_VPP2_5V 0x04 #define VG468_VPP2_12V 0x08 /* Unique Vadem registers */ #define VG469_VSENSE 0x1f /* Card voltage sense */ #define VG469_VSELECT 0x2f /* Card voltage select */ #define VG468_CTL 0x38 /* Control register */ #define VG468_TIMER 0x39 /* Timer control */ #define VG468_MISC 0x3a /* Miscellaneous */ #define VG468_GPIO_CFG 0x3b /* GPIO configuration */ #define VG469_EXT_MODE 0x3c /* Extended mode register */ #define VG468_SELECT 0x3d /* Programmable chip select */ #define VG468_SELECT_CFG 0x3e /* Chip select configuration */ #define VG468_ATA 0x3f /* ATA control */ /* Flags for VG469_VSENSE */ #define VG469_VSENSE_A_VS1 0x01 #define VG469_VSENSE_A_VS2 0x02 #define VG469_VSENSE_B_VS1 0x04 #define VG469_VSENSE_B_VS2 0x08 /* Flags for VG469_VSELECT */ #define VG469_VSEL_VCC 0x03 #define VG469_VSEL_5V 0x00 #define VG469_VSEL_3V 0x03 #define VG469_VSEL_MAX 0x0c #define VG469_VSEL_EXT_STAT 0x10 #define VG469_VSEL_EXT_BUS 0x20 #define VG469_VSEL_MIXED 0x40 #define VG469_VSEL_ISA 0x80 /* Flags for VG468_CTL */ #define VG468_CTL_SLOW 0x01 /* 600ns memory timing */ #define VG468_CTL_ASYNC 0x02 /* Asynchronous bus clocking */ #define VG468_CTL_TSSI 0x08 /* Tri-state some outputs */ #define VG468_CTL_DELAY 0x10 /* Card detect debounce */ #define VG468_CTL_INPACK 0x20 /* Obey INPACK signal? */ #define VG468_CTL_POLARITY 0x40 /* VCCEN polarity */ #define VG468_CTL_COMPAT 0x80 /* Compatibility stuff */ #define VG469_CTL_WS_COMPAT 0x04 /* Wait state compatibility */ #define VG469_CTL_STRETCH 0x10 /* LED stretch */ /* Flags for VG468_TIMER */ #define VG468_TIMER_ZEROPWR 0x10 /* Zero power control */ #define VG468_TIMER_SIGEN 0x20 /* Power up */ #define VG468_TIMER_STATUS 0x40 /* Activity timer status */ #define VG468_TIMER_RES 0x80 /* Timer resolution */ #define VG468_TIMER_MASK 0x0f /* Activity timer timeout */ /* Flags for VG468_MISC */ #define VG468_MISC_GPIO 0x04 /* General-purpose IO */ #define VG468_MISC_DMAWSB 0x08 /* DMA wait state control */ #define VG469_MISC_LEDENA 0x10 /* LED enable */ #define VG468_MISC_VADEMREV 0x40 /* Vadem revision control */ #define VG468_MISC_UNLOCK 0x80 /* Unique register lock */ /* Flags for VG469_EXT_MODE_A */ #define VG469_MODE_VPPST 0x03 /* Vpp steering control */ #define VG469_MODE_INT_SENSE 0x04 /* Internal voltage sense */ #define VG469_MODE_CABLE 0x08 #define VG469_MODE_COMPAT 0x10 /* i82365sl B or DF step */ #define VG469_MODE_TEST 0x20 #define VG469_MODE_RIO 0x40 /* Steer RIO to INTR? */ /* Flags for VG469_EXT_MODE_B */ #define VG469_MODE_B_3V 0x01 /* 3.3v for socket B */ #endif /* _LINUX_VG468_H */
