/* SPDX-License-Identifier: GPL-2.0 */
#ifndef _ASM_X86_SERIAL_H
#define _ASM_X86_SERIAL_H

/*
 * This assumes you have a 1.8432 MHz clock for your UART.
 *
 * It'd be nice if someone built a serial card with a 24.576 MHz
 * clock, since the 16550A is capable of handling a top speed of 1.5
 * megabits/second; but this requires a faster clock.
 */
#define BASE_BAUD (1843200/16)

/* Standard COM flags (except for COM4, because of the 8514 problem) */
#ifdef CONFIG_SERIAL_8250_DETECT_IRQ
# define STD_COMX_FLAGS (UPF_BOOT_AUTOCONF |    UPF_SKIP_TEST   | UPF_AUTO_IRQ)
# define STD_COM4_FLAGS (UPF_BOOT_AUTOCONF |    0               | UPF_AUTO_IRQ)
#else
# define STD_COMX_FLAGS (UPF_BOOT_AUTOCONF |    UPF_SKIP_TEST   | 0             )
# define STD_COM4_FLAGS (UPF_BOOT_AUTOCONF |    0               | 0             )
#endif

#define SERIAL_PORT_DFNS                                                                \
        /* UART         CLK             PORT    IRQ     FLAGS                       */  \
        { .uart = 0,    BASE_BAUD,      0x3F8,  4,      STD_COMX_FLAGS  }, /* ttyS0 */  \
        { .uart = 0,    BASE_BAUD,      0x2F8,  3,      STD_COMX_FLAGS  }, /* ttyS1 */  \
        { .uart = 0,    BASE_BAUD,      0x3E8,  4,      STD_COMX_FLAGS  }, /* ttyS2 */  \
        { .uart = 0,    BASE_BAUD,      0x2E8,  3,      STD_COM4_FLAGS  }, /* ttyS3 */

#endif /* _ASM_X86_SERIAL_H */