wl1271_warning
wl1271_warning("wl1271 bitmap config opt failed: %d", ret);
wl1271_warning("FEM index from ini out of bounds");
wl1271_warning("CMD_INI_FILE_GENERAL_PARAM failed");
wl1271_warning("FEM index from FW out of bounds");
wl1271_warning("CMD_INI_FILE_RADIO_PARAM failed");
wl1271_warning("CMD_INI_FILE_RADIO_PARAM failed");
wl1271_warning("TEST_CMD_INI_FILE_RF_EXTENDED_PARAM failed");
wl1271_warning("FEM index from INI out of bounds");
wl1271_warning("CMD_INI_FILE_GENERAL_PARAM failed");
wl1271_warning("FEM index from FW out of bounds");
wl1271_warning("chip id 0x%x (1271 PG10) support is obsolete",
wl1271_warning("unsupported chip id: 0x%x", wl->chip.id);
wl1271_warning("Top register access timed out.");
wl1271_warning("Top register access returned error.");
wl1271_warning("acx peer ht operation mode failed: %d", ret);
wl1271_warning("acx ht capabilities setting failed: %d", ret);
wl1271_warning("acx interrupt notify setting failed: %d", ret);
wl1271_warning("acx rx ba activity filter setting failed: %d",
wl1271_warning("acx config ap-sleep failed: %d", ret);
wl1271_warning("acx config dynamic fw traces failed: %d", ret);
wl1271_warning("acx time sync cfg failed: %d", ret);
wl1271_warning("wl1271 bitmap config opt failed: %d", ret);
wl1271_warning("failed to set Tx checksum state: %d", ret);
wl1271_warning("failed to clear firmware statistics: %d", ret);
wl1271_warning("illegal channel");
wl1271_warning("illegal radar_debug_mode value!");
wl1271_warning("value is not in valid!");
wl1271_warning("falling back to default config");
wl1271_warning("MAC address from fuse not available, using random locally administered addresses.");
wl1271_warning("chip id 0x%x (185x PG10) is deprecated",
wl1271_warning("unsupported chip id: 0x%x", wl->chip.id);
wl1271_warning("illegal id in tx completion: %d", id);
wl1271_warning("configure of tx power failed: %d", ret);
wl1271_warning("wl1271 rx config opt failed: %d", ret);
wl1271_warning("acx bet enable failed: %d", ret);
wl1271_warning("failed to set arp ip filter: %d", ret);
wl1271_warning("acx pm config failed: %d", ret);
wl1271_warning("acx keep alive mode failed: %d", ret);
wl1271_warning("acx keep alive config failed: %d", ret);
wl1271_warning("acx rssi snr trigger setting failed: %d", ret);
wl1271_warning("acx rssi snr trigger weights failed: %d", ret);
wl1271_warning("acx ht capabilities setting failed: %d", ret);
wl1271_warning("acx ht information setting failed: %d", ret);
wl1271_warning("acx ba initiator policy failed: %d", ret);
wl1271_warning("acx ba receiver session failed: %d", ret);
wl1271_warning("no fw rx ba on tid %d", tid_index);
wl1271_warning("acx tsf info interrogate failed");
wl1271_warning("acx ps rx streaming failed: %d", ret);
wl1271_warning("acx ap max tx retry failed: %d", ret);
wl1271_warning("acx config ps failed: %d", ret);
wl1271_warning("acx set inconnaction sta failed: %d", ret);
wl1271_warning("acx fm coex setting failed: %d", ret);
wl1271_warning("acx set rate mgmt params failed: %d", ret);
wl1271_warning("acx config hangover failed: %d", ret);
wl1271_warning("acx roaming statistics failed: %d", ret);
wl1271_warning("failed to set rx msdu life time: %d", ret);
wl1271_warning("acx default rx filter enable failed: %d", ret);
wl1271_warning("setting rx filter failed: %d", ret);
wl1271_warning("failed to set slot time: %d", ret);
wl1271_warning("failed to set group addr table: %d", ret);
wl1271_warning("failed to set service period timeout: %d",
wl1271_warning("failed to set rts threshold: %d", ret);
wl1271_warning("failed to set dco itrim parameters: %d", ret);
wl1271_warning("failed to set beacon filter opt: %d", ret);
wl1271_warning("failed to set beacon filter table: %d", ret);
wl1271_warning("could not set wake up conditions: %d", ret);
wl1271_warning("failed to set connection monitor "
wl1271_warning("failed to set softgemini enable: %d", ret);
wl1271_warning("failed to set sg config: %d", ret);
wl1271_warning("failed to set cca threshold: %d", ret);
wl1271_warning("failed to set rx config: %d", ret);
wl1271_warning("failed to set aid: %d", ret);
wl1271_warning("failed to set acx_event_mbox_mask: %d", ret);
wl1271_warning("Setting of preamble failed: %d", ret);
wl1271_warning("Setting of ctsprotect failed: %d", ret);
wl1271_warning("acx statistics failed: %d", ret);
wl1271_warning("Setting of rate policies failed: %d", ret);
wl1271_warning("Setting of rate policies failed: %d", ret);
wl1271_warning("Setting of rate policies failed: %d", ret);
wl1271_warning("Setting of ap rate policy failed: %d", ret);
wl1271_warning("acx ac cfg failed: %d", ret);
wl1271_warning("Setting of tid config failed: %d", ret);
wl1271_warning("Setting of frag threshold failed: %d", ret);
wl1271_warning("Setting of tx options failed: %d", ret);
wl1271_warning("wl1271 mem config failed: %d", ret);
wl1271_warning("fw version incorrect value");
wl1271_warning("cmd set_template failed: %d", ret);
wl1271_warning("cmd build null data failed %d", ret);
wl1271_warning("cmd build klv null data failed %d", ret);
wl1271_warning("Unknown encryption type: %d",
wl1271_warning("cmd set_default_wep_key failed: %d", ret);
wl1271_warning("could not set keys");
wl1271_warning("could not set ap keys");
wl1271_warning("ap start - unknown band: %d", (int)wlvif->band);
wl1271_warning("TEST command failed");
wl1271_warning("CONFIGURE command NOK");
wl1271_warning("debugfs chip_op_handler with no callback");
wl1271_warning("illegal value in fw_logger");
wl1271_warning("fw_logger value must be 1-UART 2-SDIO");
wl1271_warning("invalid operation - fw logger disabled by default, please change mode via wlconf");
wl1271_warning("illegal value for " #param); \
wl1271_warning(#param " is not in valid range"); \
wl1271_warning("illegal value in gpio_power");
wl1271_warning("illegal value in dynamic_ps");
wl1271_warning("dynamic_ps_timeout is not in valid range");
wl1271_warning("illegal value in forced_ps");
wl1271_warning("forced_ps should be either 0 or 1");
wl1271_warning("illegal value in split_scan_timeout");
wl1271_warning("illegal value for dtim_interval");
wl1271_warning("dtim value is not in valid range");
wl1271_warning("illegal value for suspend_dtim_interval");
wl1271_warning("suspend_dtim value is not in valid range");
wl1271_warning("illegal value for beacon_interval");
wl1271_warning("beacon interval value is not in valid range");
wl1271_warning("illegal value in rx_streaming_interval!");
wl1271_warning("value is not in range!");
wl1271_warning("illegal value in rx_streaming_write!");
wl1271_warning("value is not in valid!");
wl1271_warning("illegal value for beacon_filtering!");
wl1271_warning("illegal value in sleep_auth");
wl1271_warning("sleep_auth must be between 0 and %d",
wl1271_warning("Enable for recovery failed");
wl1271_warning("Failed to allocate a dummy packet skb");
wl1271_warning("No mask in WoWLAN pattern");
wl1271_warning("RX Filter too complex. Too many segments");
wl1271_warning("RX filter pattern is too big");
wl1271_warning("Max fields per RX filter. can't alloc another");
wl1271_warning("Failed to allocate RX filter pattern");
wl1271_warning("Failed to alloc rx filter");
wl1271_warning("Bad wowlan pattern %d", i);
wl1271_warning("Failed to create an RX filter from "
wl1271_warning("postponing suspend to perform recovery");
wl1271_warning("couldn't prepare device to suspend");
wl1271_warning("queuing forgotten recovery on resume");
wl1271_warning("trying to record key replacement");
wl1271_warning("build arp rsp failed: %d", ret);
wl1271_warning("wl1271_op_set_frag_threshold failed: %d", ret);
wl1271_warning("set rts threshold failed: %d", ret);
wl1271_warning("Set slot time failed %d", ret);
wl1271_warning("Set ctsprotect failed %d", ret);
wl1271_warning("Set ht information failed %d", ret);
wl1271_warning("cmd join failed %d", ret);
wl1271_warning("enter %s ps failed %d",
wl1271_warning("exit auto ps failed %d", ret);
wl1271_warning("Set ht cap failed %d", ret);
wl1271_warning("Set ht information failed %d",
wl1271_warning("build arp rsp failed: %d", ret);
wl1271_warning("could not allocate HLID - too much stations");
wl1271_warning("could not allocate HLID - too many links");
wl1271_warning("active roc on role %d", active_roc);
wl1271_warning("NIC part of the MAC address wraps around!");
wl1271_warning("Detected unconfigured mac address in nvs, derive from fuse instead.");
wl1271_warning("This default nvs file can be removed from the file system");
wl1271_warning("Your device performance is not optimized.");
wl1271_warning("Please use the calibrator tool to configure your device.");
wl1271_warning("Fuse mac address is zero. using random mac");
wl1271_warning("ELP wakeup timeout!");
wl1271_warning("trying to set ps to unsupported mode %d", mode);
wl1271_warning("corrupted packet in RX: status: 0x%x len: %d",
wl1271_warning("received empty data");
wl1271_warning("Request to enable an already "
wl1271_warning("Michael MIC error. Desc: 0x%x",
wl1271_warning("incorrect value written to bt_coex_mode");
wl1271_warning("testmode cmd: radio status=%d",
wl1271_warning("testmode cmd interrogate failed: %d", ret);
wl1271_warning("testmode cmd configure failed: %d", ret);
wl1271_warning("testmode cmd test failed: %d", ret);
wl1271_warning("Unable to flush all TX buffers, "
wl1271_warning("TX result illegal id: %d", id);
wl1271_warning("TX result overflow from chipset: %d", count);