ath_err
ath_err(common, "%s: eeprom data has to be provided externally\n",
ath_err(common, "Invalid channel %u MHz\n", freq);
ath_err(common, "Invalid channel %u MHz\n", freq);
ath_err(ath9k_hw_common(ah), "ar5416SetRfRegs failed\n");
ath_err(ath9k_hw_common(ah),
ath_err(common, "spectral scan wait failed\n");
ath_err(ath9k_hw_common(ah),
ath_err(common, "Invalid calibration type\n");
ath_err(common, "BTCOEX control register is dead\n");
ath_err(common, "spectral scan wait failed\n");
ath_err(ath9k_hw_common(ah), "Could not stop baseband\n");
ath_err(common, "Failed to stop Rx DMA in 10ms AR_CR=0x%08x AR_DIAG_SW=0x%08x\n",
ath_err(common, "dma_mapping_error on beaconing\n");
ath_err(common, "Unable to update h/w beacon queue parameters\n");
ath_err(common, "spectrum analyzer not implemented on this hardware\n");
ath_err(common, "spectrum analyzer not implemented on this hardware\n");
ath_err(common, "Reading Magic # failed\n");
ath_err(common,
ath_err(common, "Bad EEPROM checksum 0x%x\n", sum);
ath_err(common, "Bad EEPROM VER 0x%04x or REV 0x%04x\n",
ath_err(ath9k_hw_common(ah),
ath_err(common, "Unable to set BTCOEX parameters\n");
ath_err(common, "Unable to setup BEACON xmit queue\n");
ath_err(common, "Unable to setup CAB xmit queue\n");
ath_err(common, "Unable to setup xmit queue for BE traffic\n");
ath_err(common, "Unable to setup xmit queue for BK traffic\n");
ath_err(common, "Unable to setup xmit queue for VI traffic\n");
ath_err(common, "Unable to setup xmit queue for VO traffic\n");
ath_err(common,
ath_err(common, "Unable to create debugfs files\n");
ath_err(common,
ath_err(common, "Unable to remove interface at idx: %d\n",
ath_err(common, "Unable to set channel\n");
ath_err(common, "TXQ Update failed\n");
ath_err(ath9k_hw_common(priv->ah), "Unknown AMPDU action\n");
ath_err(common,
ath_err(common,
ath_err(common,
ath_err(common,
ath_err(common, "Unable to remove monitor interface at idx: %d\n",
ath_err(common, "Unable to add station entry for monitor mode\n");
ath_err(common, "Unable to remove station entry for monitor mode\n");
ath_err(common,
ath_err(common,
ath_err(common,
ath_err(common,
ath_err(common, "Invalid EPID: %d\n", epid);
ath_err(common, "Unsupported EPID: %d\n", tx_ctl->epid);
ath_err(ath9k_hw_common(ah),
ath_err(common, "qnum %u out of range, max %zu!\n",
ath_err(common, "Corrupted RX frame, dropping (len: %d)\n",
ath_err(common,
ath_err(ath9k_hw_common(ah),
ath_err(common, "Could not kill baseband RX\n");
ath_err(common, "Failed to do fast channel change\n");
ath_err(common, "Failed to set channel\n");
ath_err(common, "Chip reset failed\n");
ath_err(ath9k_hw_common(ah),
ath_err(ath9k_hw_common(ah),
ath_err(common, "Unknown power mode %u\n", mode);
ath_err(common, "both bands are disabled\n");
ath_err(ath9k_hw_common(ah), "request GPIO%d failed:%d\n",
ath_err(ath9k_hw_common(ah),
ath_err(common,
ath_err(common,
ath_err(common, "eeprom contains invalid mac address: %pM\n",
ath_err(common, "random mac address will be used: %pM\n",
ath_err(common, "Could not read hardware revisions");
ath_err(common,
ath_err(common, "Couldn't reset chip\n");
ath_err(common, "Couldn't wakeup chip\n");
ath_err(common, "Hardware device ID 0x%04x not supported\n",
ath_err(common,
ath_err(common, "PLL4 measurement not done\n");
ath_err(common, "Unable to create debugfs files\n");
ath_err(common, "ath_desc not DWORD aligned\n");
ath_err(ath9k_hw_common(ah),
ath_err(ath9k_hw_common(ah),
ath_err(common, "Invalid TX queue type: %u\n", type);
ath_err(common, "TX queue: %u already active\n", q);
ath_err(ath9k_hw_common(ah),
ath_err(common,
ath_err(ath9k_hw_common(ah),
ath_err(common, "TXQ Update failed\n");
ath_err(ath9k_hw_common(sc->sc_ah), "Unknown AMPDU action\n");
ath_err(common,
ath_err(common,
ath_err(common, "TX while HW is in FULL_SLEEP mode\n");
ath_err(common, "Failed to initialize MCI\n");
ath_err(common,
ath_err(common,
ath_err(common,
ath_err(common,
ath_err(common, "Device not present\n");
ath_err(common, "None of the WoW triggers enabled\n");
ath_err(common,
ath_err(common,
ath_err(ath9k_hw_common(sc->sc_ah),
ath_err(ath9k_hw_common(sc->sc_ah),
ath_err(common,
ath_err(common,
ath_err(common, "set-entry: keycache entry %u out of range\n",
ath_err(common, "cipher %u not supported\n", k->kv_type);
ath_err(common, "Setting TX MIC Key Failed\n");
ath_err(common, "keyreset: keycache entry %u out of range\n",
ath_err(common, "keysetmac: keycache entry %u out of range\n",