/* $NetBSD: ipaq_atmel.h,v 1.3 2008/04/28 20:23:21 martin Exp $ */ /*- * Copyright (c) 2001 The NetBSD Foundation, Inc. All rights reserved. * * This code is derived from software contributed to The NetBSD Foundation * by Ichiro FUKUHARA (ichiro@ichiro.org). * * Redistribution and use in source and binary forms, with or without * modification, are permitted provided that the following conditions * are met: * 1. Redistributions of source code must retain the above copyright * notice, this list of conditions and the following disclaimer. * 2. Redistributions in binary form must reproduce the above copyright * notice, this list of conditions and the following disclaimer in the * documentation and/or other materials provided with the distribution. * * THIS SOFTWARE IS PROVIDED BY THE NETBSD FOUNDATION, INC. AND CONTRIBUTORS * ``AS IS'' AND ANY EXPRESS OR IMPLIED WARRANTIES, INCLUDING, BUT NOT LIMITED * TO, THE IMPLIED WARRANTIES OF MERCHANTABILITY AND FITNESS FOR A PARTICULAR * PURPOSE ARE DISCLAIMED. IN NO EVENT SHALL THE FOUNDATION OR CONTRIBUTORS * BE LIABLE FOR ANY DIRECT, INDIRECT, INCIDENTAL, SPECIAL, EXEMPLARY, OR * CONSEQUENTIAL DAMAGES (INCLUDING, BUT NOT LIMITED TO, PROCUREMENT OF * SUBSTITUTE GOODS OR SERVICES; LOSS OF USE, DATA, OR PROFITS; OR BUSINESS * INTERRUPTION) HOWEVER CAUSED AND ON ANY THEORY OF LIABILITY, WHETHER IN * CONTRACT, STRICT LIABILITY, OR TORT (INCLUDING NEGLIGENCE OR OTHERWISE) * ARISING IN ANY WAY OUT OF THE USE OF THIS SOFTWARE, EVEN IF ADVISED OF THE * POSSIBILITY OF SUCH DAMAGE. */ /* * Atmel microcontroller (Proxy Controller for StrongARM) */ /* Frame character */ #define FRAME_SOF 0x02 /* Start of Frame character */ #define FRAME_EOF 0x04 /* End of Frame character */ #define FRAME_OVERHEAD_SIZE 3 /* FRAME_SOF + (ID+len) + checksum */ /* ID */ #define ID_VERSION 0x00 /* Get version ID */ #define EVENT_BUTTON 0x02 /* Get event of BUTTON */ #define EVENT_TS 0x03 /* Get event of Touch Screen */ #define READ_EEPROM 0x04 /* Read EEPROM */ #define WRITE_EEPROM 0x05 /* Write EEPROM */ #define SW_LED 0x08 /* Switch of LED */ #define STATUS_BATTERY 0x09 /* Get status of battery */ #define READ_IIC 0x0b /* Read data via IIC protocol */ #define WRITE_IIC 0x0c /* Write data via IIC protocol */ #define SET_BACKLIGHT 0x0d /* Backlight Control command */ #define STATUS_EXTP 0xa1 /* Get status of Extension Pack */ #define MAX_SENDSIZE 32 /* maximum data size of sendData() */ #define MAX_RECVSIZE 16 /* maximum data size of recv data */ /* * Battery status */ #define BATT_STATUS_HIGH 0x00 #define BATT_STATUS_LOW 0x01 #define BATT_STATUS_CRITICAL 0x02 #define BATT_STATUS_CHARGING 0x04 #define BATT_STATUS_CHARGING_MAIN 0x10 #define BATT_STATUS_NOBATT 0x80 #define BATT_STATUS_UNKNOWN 0xff /* * AC status */ #define AC_STATUS_OFFLINE 0x00 #define AC_STATUS_ONLINE 0x01 #define AC_STATUS_BACKUP 0x02 #define AC_STATUS_UNKNOWN 0xff /* * kind of battery */ #define BATT_ALKALINE 0x01 #define BATT_NICD 0x02 #define BATT_NIMH 0x03 #define BATT_LION 0x04 #define BATT_LIPOLY 0x05 #define BATT_UNKNOWN 0xff
