ATH5K_ERR
ATH5K_ERR(ah, "spur immunity level %d out of range",
ATH5K_ERR(ah, "firstep level %d out of range", level);
ATH5K_ERR(ah, "ANI mode %d out of range", mode);
ATH5K_ERR(ah, "noise immunity level %d out of range",
ATH5K_ERR(ah, "Couldn't identify radio revision.\n");
ATH5K_ERR(ah, "Device not yet supported.\n");
ATH5K_ERR(ah, "unable to init EEPROM\n");
ATH5K_ERR(ah, "unable to get device capabilities\n");
ATH5K_ERR(ah, "POST Failed !!!\n");
ATH5K_ERR(ah, "POST Failed !!!\n");
ATH5K_ERR(ah, "%s: unable to update parameters for beacon "
ATH5K_ERR(ah, "error in processing rx descriptor\n");
ATH5K_ERR(ah, "tx hdrlen not %%4: not enough"
ATH5K_ERR(ah, "no further txbuf available, dropping packet\n");
ATH5K_ERR(ah,
ATH5K_ERR(ah, "beacon DMA mapping failed\n");
ATH5K_ERR(ah, "calibration of channel %u failed\n",
ATH5K_ERR(ah, "request_irq failed\n");
ATH5K_ERR(ah, "can't reset hardware (%d)\n", ret);
ATH5K_ERR(ah, "can't start recv logic\n");
ATH5K_ERR(ah, "can't get channels\n");
ATH5K_ERR(ah, "can't allocate descriptors\n");
ATH5K_ERR(ah, "can't setup a beacon xmit queue\n");
ATH5K_ERR(ah, "can't setup cab queue\n");
ATH5K_ERR(ah, "can't setup xmit queue\n");
ATH5K_ERR(ah, "can't setup xmit queue\n");
ATH5K_ERR(ah, "can't setup xmit queue\n");
ATH5K_ERR(ah, "can't setup xmit queue\n");
ATH5K_ERR(ah, "can't setup xmit queue\n");
ATH5K_ERR(ah, "unable to read address from EEPROM\n");
ATH5K_ERR(ah, "can't initialize regulatory system\n");
ATH5K_ERR(ah, "can't register ieee80211 hw\n");
ATH5K_ERR(ah, "can't alloc skbuff of size %u\n",
ATH5K_ERR(ah, "%s: DMA mapping failed\n", __func__);
ATH5K_ERR(ah, "%s: could not setup RX desc\n", __func__);
ATH5K_ERR(ah, "can't allocate descriptors\n");
ATH5K_ERR(ah, "can't allocate bufptr\n");
ATH5K_ERR(ah, "zero retries\n");
ATH5K_ERR(ah, "zero rate\n");
ATH5K_ERR(ah, "zero retries\n");
ATH5K_ERR(ah, "zero rate\n");
ATH5K_ERR(ah, "zero rate\n");
ATH5K_ERR(ah, "Invalid max custom EEPROM size: "
ATH5K_ERR(ah, "Invalid EEPROM "
ATH5K_ERR(ah, "unsupported channel mode: %d\n", mode);
ATH5K_ERR(ah,
ATH5K_ERR(ah, "Only one single ad-hoc interface is allowed.\n");
ATH5K_ERR(ah,
ATH5K_ERR(ah, "calibration timeout (%uMHz)\n",
ATH5K_ERR(ah, "invalid tx power: %u\n", txpower);
ATH5K_ERR(ah, "gain calibration timeout (%uMHz)\n",
ATH5K_ERR(ah, "out of memory\n");
ATH5K_ERR(ah, "invalid bank\n");
ATH5K_ERR(ah,
ATH5K_ERR(ah,
ATH5K_ERR(ah,
ATH5K_ERR(ah,
ATH5K_ERR(ah,
ATH5K_ERR(ah, "failed to wakeup the MAC Chip\n");
ATH5K_ERR(ah, "failed to put device on warm reset\n");
ATH5K_ERR(ah, "failed to put device on hold\n");
ATH5K_ERR(ah, "failed to wakeup the MAC Chip\n");
ATH5K_ERR(ah, "failed to reset the MAC Chip\n");
ATH5K_ERR(ah, "failed to resume the MAC Chip\n");
ATH5K_ERR(ah, "failed to warm reset the MAC Chip\n");
ATH5K_ERR(ah, "invalid radio frequency mode\n");
ATH5K_ERR(ah, "failed to create sysfs group\n");