mv_dprintk
mv_dprintk("phy hard reset failed.\n");
mv_dprintk("check SRS 0 %08X.\n", tmp);
mv_dprintk("check SRS 1 %08X.\n", tmp);
mv_dprintk("register set 0x%x was stopped.\n", reg_set);
mv_dprintk("non specific ncq error err_0:%x,err_1:%x.\n",
mv_dprintk("94xx phy %d atta frame %d %x.\n",
mv_dprintk("get all reg link rate is 0x%x\n", phy->phy_status);
mv_dprintk("get link rate is %d\n", sas_phy->linkrate);
mv_dprintk("interrupt coalescing timer %d us is"
mv_dprintk("set interrupt coalescing time to %d us\n",
mv_dprintk("phy %d attach dev info is %x\n",
mv_dprintk("phy %d attach sas addr is %llx\n",
mv_dprintk("found dev has gone.\n");
mv_dprintk("found dev[%d:%x] is gone.\n",
mv_dprintk("mvs_abort_task() mvi=%p task=%p "
mv_dprintk("port has not device.\n");
mv_dprintk("port %d slot %d rx_desc %X has error info"
mv_dprintk("port %d has removed.\n", slot->port->sas_port.id);
mv_dprintk("phy%d Removed Device\n", phy_no);
mv_dprintk("phy%d Attached Device\n", phy_no);
mv_dprintk("phy%d Got Broadcast Change\n", phy_no);
mv_dprintk("Get signature time out, reset phy %d\n",
mv_dprintk("phy %d ctrl sts=0x%08X.\n", phy_no+mvi->id*mvi->chip->n_phy,
mv_dprintk("phy %d irq sts = 0x%08X\n", phy_no+mvi->id*mvi->chip->n_phy,
mv_dprintk("phy %d STP decoding error.\n",
mv_dprintk("notify plug in on phy[%d]\n", phy_no);
mv_dprintk("plugin interrupt but phy%d is gone\n",
mv_dprintk("phy %d broadcast change.\n",
mv_dprintk("phy %d byte dmaded.\n", i + mvi->id * mvi->chip->n_phy);
mv_dprintk("Have not enough regiset for dev %d.\n",
mv_dprintk("device %d not ready.\n",
mv_dprintk("device %016llx not ready.\n",
mv_dprintk("SATA/STP port %d does not attach"
mv_dprintk("SAS port %d does not attach"
mv_dprintk("rc is %x\n", rc);