dbgp_printk
dbgp_printk("ehci can not be started\n");
dbgp_printk("ehci started\n");
dbgp_printk("can not reset ehci\n");
dbgp_printk("No device found in debug port\n");
dbgp_printk("No device in debug port\n");
dbgp_printk("Could not find attached debug device\n");
dbgp_printk("Could not move attached device to %d\n",
dbgp_printk("debug device renamed to 127\n");
dbgp_printk(" Could not enable the debug device\n");
dbgp_printk("debug interface enabled\n");
dbgp_printk("dbgp_bulk_write failed: %d\n", ret);
dbgp_printk("small write done\n");
dbgp_printk("set debug port to %d\n", port);
dbgp_printk("using nvidia set_debug_port\n");
dbgp_printk("dbgp: ehci BIOS state %08x\n", cap);
dbgp_printk("dbgp: BIOS handoff\n");
dbgp_printk("dbgp: BIOS handoff failed: %08x\n", cap);
dbgp_printk("debug_port: %d\n", debug_port);
dbgp_printk("n_ports: %d\n", n_ports);
dbgp_printk("portstatus%d: %08x\n", i, portsc);
dbgp_printk("dbgp: %s\n", str);
dbgp_printk(" Debug control: %08x", readl(&ehci_debug->control));
dbgp_printk(" ehci cmd : %08x", readl(&ehci_regs->command));
dbgp_printk(" ehci conf flg: %08x\n",
dbgp_printk("dbgp_num: %d\n", dbgp_num);
dbgp_printk("Found EHCI debug port on %02x:%02x.%1x\n", bus, slot,
dbgp_printk("bar: %02x offset: %03x\n", bar, offset);
dbgp_printk("only debug ports on bar 1 handled.\n");
dbgp_printk(" ehci status : %08x", readl(&ehci_regs->status));
dbgp_printk("bar_val: %02x offset: %03x\n", bar_val, offset);
dbgp_printk("only simple 32bit mmio bars supported\n");
dbgp_printk(" ehci portsc : %08x\n",
dbgp_printk("mmio for ehci enabled\n");
dbgp_printk("ehci_bar: %p\n", ehci_bar);
dbgp_printk("ehci_setup failed\n");