ath6kl_warn
ath6kl_warn("failed to set scan channels, scan all channels");
ath6kl_warn("timeout, didn't get host sleep cmd processed event\n");
ath6kl_warn("error while waiting for host sleep cmd processed event %d\n",
ath6kl_warn("clear wmi ctrl data timeout\n");
ath6kl_warn("clear wmi ctrl data failed: %d\n", left);
ath6kl_warn("Failed to configure host sleep mode for wow resume: %d\n",
ath6kl_warn("failed to stop hw during suspend: %d\n",
ath6kl_warn("wow mode resume failed: %d\n", ret);
ath6kl_warn("deep sleep resume failed: %d\n", ret);
ath6kl_warn("Failed to boot hw in resume: %d\n", ret);
ath6kl_warn("Failed to set beacon interval: %d\n", ret);
ath6kl_warn("Failed to set dtim_period in beacon: %d\n", ret);
ath6kl_warn("Failed to set probe request IE for scheduled scan: %d\n",
ath6kl_warn("failed to disable scan during stop\n");
ath6kl_warn("ath6kl_deep_sleep_enable: wmi_powermode_cmd failed\n");
EXPORT_SYMBOL(ath6kl_warn);
ath6kl_warn("Unable to read memory:%u\n", addr);
__printf(1, 2) void ath6kl_warn(const char *fmt, ...);
ath6kl_warn("firmware crashed\n");
ath6kl_warn("Failed to clear debug interrupt: %d\n", ret);
ath6kl_warn("failed to get ptr to register dump area: %d\n",
ath6kl_warn("failed to get register dump: %d\n", ret);
ath6kl_warn("Rx buffer requested with invalid length htc_hdr:eid %d, flags 0x%x, len %d\n",
ath6kl_warn("%s(): partial bundle detected num:%d , %d\n",
ath6kl_warn("host is going to stop blocking receiver for htc_stop\n");
ath6kl_warn("host has no rx buffers blocking receiver to prevent overrun\n");
ath6kl_warn("credit size: %d is not block aligned! Disabling send bundling\n",
ath6kl_warn("htc pipe control receive timeout!\n");
ath6kl_warn("invalid htc pipe ready msg len: %d\n",
ath6kl_warn("invalid htc pipe ready msg: 0x%x\n",
ath6kl_warn("firmware capability buffer too small!\n");
ath6kl_warn("htc wait target timed out, resetting device\n");
ath6kl_warn("failed to power off hif: %d\n", ret);
ath6kl_warn("No \"%s\" property on %pOFn node.\n",
ath6kl_warn("Failed to get board file %s (%d), trying to find default board file.\n",
ath6kl_warn("WARNING! No proper board file was not found, instead using a default board file.\n");
ath6kl_warn("Most likely your hardware won't work as specified. Install correct board file!\n");
ath6kl_warn("testmode 2 not supported\n");
ath6kl_warn("testmode 1 not supported\n");
ath6kl_warn("Failed to %s multicast-all receive\n",
ath6kl_warn("Failed to remove multicast filter:%pM\n",
ath6kl_warn("Failed to add multicast filter :%pM\n",
ath6kl_warn("failed to read32 through diagnose window: %d\n",
ath6kl_warn("Invalid address for debug_hdr_addr\n");
ath6kl_warn("Failed to send hb challenge request, err:%d\n",
ath6kl_warn("hif scatter resource setup failed, trying virtual scatter method\n");
ath6kl_warn("failed to allocate testmode rx skb!\n");
ath6kl_warn("nla_put failed on testmode rx skb!\n");
ath6kl_warn("failed to add wmi data header:%d\n"
ath6kl_warn("tx complete error: %d\n", status);
ath6kl_warn("diag_write32 failed: %d\n", ret);
ath6kl_warn("Failed to submit usb control message: %d\n", ret);
ath6kl_warn("Failed to read usb control message: %d\n", ret);
ath6kl_warn("diag read32 failed: %d\n", ret);
ath6kl_warn("Regpair not found reg_code 0x%0x\n",
ath6kl_warn("invalid multicast filter address\n");
ath6kl_warn("unknown cmd id 0x%x\n", id);