SHOW_INFO
SHOW_INFO(2, "%x", buffer[0]);
SHOW_INFO( 2, "H: %4d %4d %4d %4d (v=%4d)",
SHOW_INFO( 2, "V: %4d %4d %4d %4d (h=%4d)",
SHOW_INFO( 2, "clk: %ld", target->timing.pixel_clock );
SHOW_INFO( 4, "H: %4d %4d %4d %4d",
SHOW_INFO( 4, "V: %4d %4d %4d %4d",
SHOW_INFO( 4, "clk: %ld", timing->pixel_clock );
SHOW_INFO(0, "Detected monitors: 0x%x", displays);
SHOW_INFO(2, "Found %s CRT connected to CRT-DAC",
SHOW_INFO(2, "h_disp=%d, h_blank=%d, h_over_plus=%d, h_sync_width=%d",
SHOW_INFO(2, "v_disp=%d, v_blank=%d, v_over_plus=%d, v_sync_width=%d",
SHOW_INFO(2, "pixel_clock=%d kHz", fp->dot_clock);
SHOW_INFO(2, "Port %d:- \nMonitor: %s\nConn Type: %s\nDDC Port: %s\nTMDS Type: %s\nDAC Type: %s",
SHOW_INFO( 2, "frame_rate_drift=%d, crt_freq=%d, v_total=%d, h_total=%d",
SHOW_INFO( 2, "Rage Theatre found on VIP channel %d", channel );
SHOW_INFO(3, "device type: %d, qualifier: %d, removable: %d, ANSI version: %d, response data format: %d\n"
SHOW_INFO(3, "additional_length: %d", new_inquiry_data->additional_length + 4);
SHOW_INFO(3, "standard: %04x", standard);
SHOW_INFO(1, "need to setup contiguous DMA buffer of size %" B_PRIu32,
SHOW_INFO(3, "Got up to %" B_PRIu32 " S/G entries to original data",
SHOW_INFO(1, "bytes: %" B_PRIu32, request->data_length);
SHOW_INFO(2, "Restricting device queue to %d requests", num_requests);
SHOW_INFO( 3, "CP buffer address=%" B_PRIx32, cp->ring.vm_base );
SHOW_INFO( 3, "CP buffer size mask=%d", radeon_log2( cp->ring.size / 2 ) );
SHOW_INFO( 3, "CP read pointer buffer==%" B_PRIx32,
SHOW_INFO(3, "GATT_ptr=%p, GATT_phys=%#" B_PRIx32, gart->GATT.ptr, gart->GATT.phys);
SHOW_INFO(4, "Device is a hostbridge, subclass ID is $%02x", ai.class_sub);
SHOW_INFO(4, "Vendor ID $%04x", ai.vendor_id);
SHOW_INFO(4, "Device ID $%04x", ai.device_id);
SHOW_INFO(4, "Bus %d, device %d, function %d", ai.bus, ai.device, ai.function);
SHOW_INFO(4,
SHOW_INFO(1, "%" B_PRIu32 " queued AGP requests can be handled.",
SHOW_INFO(4, "Max. AGP queued request depth is set to %" B_PRIu32,
SHOW_INFO(4, "Device is a graphics card, subclass ID is $%02x", ai.class_sub);
SHOW_INFO( 1, "%" B_PRIu32 " MB %s found on %d wide bus",
SHOW_INFO( 2, "found ROM @0x%" B_PRIx32, segstart );
SHOW_INFO( 2, "TESTING "
SHOW_INFO( 2,
SHOW_INFO( 2, "Port%d: DDCType-%d, DACType-%d, TMDSType-%d, ConnectorType-%d",
SHOW_INFO( 4, "unknown ddctype %d found",
SHOW_INFO( 2, "Port%d: DDCType-%d, DACType-%d, TMDSType-%d, ConnectorType-%d",
SHOW_INFO( 2, "Port%d: DDCType-%d, DACType-%d, TMDSType-%d, ConnectorType-%d",
SHOW_INFO( 2, "Panel Info from ATOMBIOS:\n"
SHOW_INFO( 2, "Panel ID string: %s", panel_name );
SHOW_INFO( 2, "Panel Size from BIOS: %dx%d",
SHOW_INFO( 2, "detected panel size from registers: %dx%d",
SHOW_INFO( 2, "h_disp=%d, h_blank=%d, h_over_plus=%d, h_sync_width=%d",
SHOW_INFO( 2, "v_disp=%d, v_blank=%d, v_over_plus=%d, v_sync_width=%d",
SHOW_INFO( 2, "pixel_clock=%d", di->fp_info.dot_clock );
SHOW_INFO( 0,
SHOW_INFO(0, "found supported device"
SHOW_INFO(0, "found %s; ASIC: %s", device->name,
SHOW_INFO(0, "%" B_PRIu32 " supported devices", count);
SHOW_INFO( 1, "Log Info Level now %" B_PRIu32 "/4", value );
SHOW_INFO( 1, "Log Flow Level now %" B_PRIu32 "/4", value );
SHOW_INFO( 1, "Log Error Level now %" B_PRIu32 "/4", value );
SHOW_INFO( 1,
SHOW_INFO( 1,
SHOW_INFO( 2, "LVDS GEN = %8" B_PRIx32,
SHOW_INFO( 2, "LVDS PLL = %8" B_PRIx32,
SHOW_INFO( 2, "TMDS PLL = %8" B_PRIx32,
SHOW_INFO( 2, "TMDS TRANS = %8" B_PRIx32,
SHOW_INFO( 2, "FP1 GEN = %8" B_PRIx32,
SHOW_INFO( 2, "FP2 GEN = %8" B_PRIx32 ,
SHOW_INFO( 2, "TV DAC = %8" B_PRIx32 ,
SHOW_INFO( 1,
SHOW_INFO(3, "installed IRQ @ %d", di->pcii.u.h0.interrupt_line);
SHOW_INFO( 3, " local memory 0x%" B_PRIx32 "@0x%" B_PRIx32,
SHOW_INFO( 3, " PCI GART 0x%" B_PRIx32 "@0x%" B_PRIx32,
SHOW_INFO( 3, " disabled AGP GART 0x%" B_PRIx32 "@0x%" B_PRIx32,
SHOW_INFO(1, "TRIM: Setting trim support to %s",