src/add-ons/accelerants/radeon/CP.c

160

SHOW_ERROR0( 0, "All buffers are in use and engine doesn't finish any of them" );

src/add-ons/accelerants/radeon/SetDisplayMode.c

363

SHOW_ERROR0( 2, "invalid mode" );

src/add-ons/accelerants/radeon/SetDisplayMode.c

445

SHOW_ERROR0( 2, "no memory for cursor image!" );

src/add-ons/accelerants/radeon/SetDisplayMode.c

462

SHOW_ERROR0( 2, "no memory for frame buffer!" );

src/add-ons/accelerants/radeon/monitor_detection.c

1014

SHOW_ERROR0(2, "Disabled Ext DVI - invalid EDID");

src/add-ons/accelerants/radeon/monitor_detection.c

1024

SHOW_ERROR0(2, "Disabled DVI - invalid EDID");

src/add-ons/accelerants/radeon/monitor_detection.c

1083

SHOW_ERROR0(2, "swapping active port 2 to free port 1");

src/add-ons/accelerants/radeon/monitor_detection.c

1090

SHOW_ERROR0(2, "Reversed dac detected (not impl. yet)");

src/add-ons/accelerants/radeon/palette.c

68

SHOW_ERROR0( 2, "Tried to set palette in non-palette mode" );

src/add-ons/accelerants/radeon/theatre_out.c

260

SHOW_ERROR0( 2, "This card needs a Rage Theatre for TV-Out, but there is none." );

src/add-ons/kernel/bus_managers/scsi/scatter_gather.cpp

111

SHOW_ERROR0(2, "cannot allocate memory for IO request!");

src/add-ons/kernel/bus_managers/scsi/scsi_io.cpp

414

SHOW_ERROR0( 3, "device got removed" );

src/add-ons/kernel/bus_managers/scsi/scsi_io.cpp

436

SHOW_ERROR0( 3, "cannot create DMA buffer for request - reduce data volume" );

src/add-ons/kernel/bus_managers/scsi/scsi_io.cpp

503

SHOW_ERROR0( 3, "data is too much fragmented - you should use s/g list" );

src/add-ons/kernel/drivers/graphics/radeon/CP_setup.c

201

SHOW_ERROR0( 0, "pixel cache didn't become empty" );

src/add-ons/kernel/drivers/graphics/radeon/CP_setup.c

341

SHOW_ERROR0( 0, "Cannot allocate ring buffer" );

src/add-ons/kernel/drivers/graphics/radeon/CP_setup.c

407

SHOW_ERROR0( 0, "Cannot allocate buffers for status information" );

src/add-ons/kernel/drivers/graphics/radeon/CP_setup.c

456

SHOW_ERROR0( 0, "Cannot allocate indirect buffers" );

src/add-ons/kernel/drivers/graphics/radeon/PCI_GART.c

109

SHOW_ERROR0( 3, "cannot map buffer with WC" );

src/add-ons/kernel/drivers/graphics/radeon/PCI_GART.c

117

SHOW_ERROR0( 1, "cannot map GART buffer" );

src/add-ons/kernel/drivers/graphics/radeon/PCI_GART.c

209

SHOW_ERROR0( 0, "memory map of GART buffer too large!" );

src/add-ons/kernel/drivers/graphics/radeon/bios.c

549

SHOW_ERROR0( 2, "No Panel Info Table found in BIOS" );

src/add-ons/kernel/drivers/graphics/radeon/bios.c

560

SHOW_ERROR0( 2, "No Panel Info Table found in BIOS" );

src/add-ons/kernel/drivers/graphics/radeon/bios.c

618

SHOW_ERROR0( 2, "Radeon: couldn't get Panel Timing from BIOS" );

src/add-ons/kernel/generic/scsi_periph/block.cpp

506

SHOW_ERROR0(1, "LBA value is too large!"

src/add-ons/kernel/generic/scsi_periph/block.cpp

633

SHOW_ERROR0(1, "LBA value is too large!"

src/add-ons/kernel/generic/scsi_periph/block.cpp

644

SHOW_ERROR0(1,

src/add-ons/kernel/generic/scsi_periph/block.cpp

713

SHOW_ERROR0(1, "LBA value is too large!"

src/add-ons/kernel/generic/scsi_periph/block.cpp

724

SHOW_ERROR0(1,

src/add-ons/kernel/generic/scsi_periph/error_handling.cpp

115

SHOW_ERROR0( 2, "Write protected" );

src/add-ons/kernel/generic/scsi_periph/error_handling.cpp

131

SHOW_ERROR0(2, "No sense");

src/add-ons/kernel/generic/scsi_periph/error_handling.cpp

137

SHOW_ERROR0(2, "Recovered error");

src/add-ons/kernel/generic/scsi_periph/error_handling.cpp

146

SHOW_ERROR0(2, "Medium error");

src/add-ons/kernel/generic/scsi_periph/error_handling.cpp

150

SHOW_ERROR0(2, "Hardware error");

src/add-ons/kernel/generic/scsi_periph/error_handling.cpp

154

SHOW_ERROR0(2, "Illegal request");

src/add-ons/kernel/generic/scsi_periph/error_handling.cpp

158

SHOW_ERROR0(2, "Unit attention");

src/add-ons/kernel/generic/scsi_periph/error_handling.cpp

162

SHOW_ERROR0(2, "Data protect");

src/add-ons/kernel/generic/scsi_periph/error_handling.cpp

169

SHOW_ERROR0(2, "Is blank");

src/add-ons/kernel/generic/scsi_periph/error_handling.cpp

21

SHOW_ERROR0(2, "No auto-sense (but there should be)");

src/add-ons/kernel/generic/scsi_periph/error_handling.cpp

258

SHOW_ERROR0(2, "No device");

src/add-ons/kernel/generic/scsi_periph/error_handling.cpp

277

SHOW_ERROR0(2, "Data transmission failed");

src/add-ons/kernel/generic/scsi_periph/error_handling.cpp

283

SHOW_ERROR0(2, "Invalid request");

src/add-ons/kernel/generic/scsi_periph/error_handling.cpp

307

SHOW_ERROR0(2, "Auto-sense failed, don't know what really happened");

src/add-ons/kernel/generic/scsi_periph/error_handling.cpp

40

SHOW_ERROR0(2, "encountered DEFERRED ERROR - bye, bye");

src/add-ons/kernel/generic/scsi_periph/error_handling.cpp

60

SHOW_ERROR0(2, "LUN needs manual help");

src/add-ons/kernel/generic/scsi_periph/error_handling.cpp

77

SHOW_ERROR0(2, "Recovered write error - block got reallocated automatically");

src/add-ons/kernel/generic/scsi_periph/error_handling.cpp

81

SHOW_ERROR0(2, "Recovered ID with ECC");

src/add-ons/kernel/generic/scsi_periph/removable.cpp

32

SHOW_ERROR0( 1, "Driver doesn't support medium changes, but there occured one!?" );