DEB
DEB(printf("speed locked at %d (tried %d)\n",
DEB(printf("als_get_playback_command: invalid format 0x%08x\n",
#ifndef DEB
DEB(printf("GCR_DMA_EMULATION 0x%08x\n", v));
DEB(kprintf("cmi_attach: succeeded\n"));
DEB(kprintf("cmi_rd: failed 0x%04x %d\n", regno, size));
DEB(kprintf("cmpci_rate_to_regvalue: %d -> %d\n", rate, cmi_rates[i]));
DEB(kprintf("cmpci_regvalue_to_rate: %d -> %d\n", r, i));
DEB(kprintf("cmi_ch1_start: dma prog\n"));
DEB(kprintf("cmichan_init failed\n"));
DEB(kprintf("cmichan_setspeed (%s) %d -> %d (%d)\n",
#ifndef DEB
DEB(printf("cs4281chan_setblocksize: blksz %d Setting %d\n", blocksize, ch->blksz));
DEB(printf("cs4281_power %d -> %d\n", sc->power, state));
#ifndef DEB
DEB(device_printf(dev, "subdev = 0x%x - badcard?\n",
DEB(else)
DEB(device_printf(dev, "this is a non-ac97 NM256AV, not attaching\n"));
DEB(kprintf("ess_cmd: %x\n", val));
DEB(kprintf("ess_cmd1: %x, %x\n", cmd, val));
DEB(kprintf("ess_setmixer: reg=%x, val=%x\n", port, value);)
DEB(kprintf("ess_reset_dsp\n"));
DEB(kprintf("ess_reset_dsp failed\n"));
DEB(kprintf("ess_intr: pirq:%d rirq:%d\n",pirq,rirq));
DEB(kprintf("ess_setupch\n"));
DEB(kprintf("ess_start\n"););
DEB(kprintf("ess_stop\n"));
DEB(kprintf("done with stop\n"));
DEB(kprintf("esschan_init\n"));
DEB(kprintf("esschan_trigger: %d\n",go));
DEB(printf("set format: dir = %d, format=%x\n", ch->dir, format));
DEB(printf("ado located at va=%p pa=%x\n", ado, sgd_addr));
DEB(printf("viachan_trigger: go=%d\n", go));
DEB(printf("viachan_getptr: len / base = %x / %x\n", len, base));
DEB(printf("return ptr=%u\n", ptr));
DEB(kprintf("base 0x%08x count %5d mode 0x%02x\n",
DEB(kprintf("svchan_init failed\n"));
DEB(kprintf("svchan_setblocksize: %d\n", blocksize));
DEB(kprintf("svrchan_setspeed: %d -> PLLM 0x%02x PLLNR 0x%08x\n",
#ifndef DEB
DEB(kprintf("sv_mix_setrecsrc: mask 0x%08x adc_input 0x%02x\n", mask, v));
DEB(kprintf("Power state %d\n", state));
DEB(if (status) kprintf("intr 0x%02x ?\n", status));
DEB(kprintf("sv_attach: initial dmaa 0x%08x\n", data));
DEB(kprintf("sv_attach: initial dmac 0x%08x\n", data));
DEB(kprintf("dmaa: 0x%x 0x%x\n", data, pci_read_config(dev, SV_PCI_DMAA, 4)));
DEB(kprintf("dmac: 0x%x 0x%x\n", data, pci_read_config(dev, SV_PCI_DMAC, 4)));
DEB(kprintf("sv_attach: succeeded\n"));
DEB(kprintf("chn_flush: c->flags 0x%08x\n", c->flags));
DEB( kprintf("FIOASYNC\n") ; )
DEB( kprintf("FIONBIO\n") ; )
DEB(kprintf("dsp reset\n"));
DEB(kprintf("dsp sync\n"));
DEB(kprintf("SNDCTL_DSP_SETFRAGMENT 0x%08x\n", *(int *)arg));
DEB(kprintf("SNDCTL_DSP_SETFRAGMENT %d frags, %d sz\n", maxfrags, fragsz));
DEB(kprintf("default ioctl fn 0x%08lx fail\n", cmd));
#ifndef DEB